User's Manual

ManualsBrandsVestel Electronics ManualsElectronicsBluetooth module for consumer electronics equipment

17BT02

Product Specification

and User Manual

1. General Description

The 17BT02 is used in Linux based platforms, it is working as a daughter board for connecting

wireless sound devices and HID devices. It supports one connector to attach main boards. The

socket uses USB signal interface at 5V supply voltage. Bluetooth module with Bluetooth 4.2

Modulations: GFSK, π/4 DQPSK, 8DPSK are used. Bluetooth Low Energy functionality disabled

by firmware.

2. Features

 BT4.2 compliant

 A2DP source and HID profiles

 Printed PCB antenna

 USB interface

 20Mhz Crystal

3. Key Specifications

Main chipset

CYW20705B, Cypress

Frequency range

2402-2480 MHz

Channels

0-78

Host interface

USB

Summary of content (4 pages)

PAGE 1
7BT02 Product Specification and User Manual 1. General Description The 17BT02 is used in Linux based platforms, it is working as a daughter board for connecting wireless sound devices and HID devices. It supports one connector to attach main boards. The socket uses USB signal interface at 5V supply voltage. Bluetooth module with Bluetooth 4.2 Modulations: GFSK, π/4 DQPSK, 8DPSK are used. Bluetooth Low Energy functionality disabled by firmware. 2. Features  BT4.
PAGE 2
4. Electrical Specifications 4.1. Power supply voltages DC supply to module VCC Min 4.75 V Typ 5V Max 5.25 V 5. RF Characteristic 5.1. Antenna Gain Antenna 0 2.4 Ghz 0.84 dBi 5.2. TX/RX Characteristic 17BT02 DH1 3DH5 Channel Tx Power (dBm) Rx Sensitivity (dBm) Tx Power (dBm) Rx Sensitivity (dBm) Ch_0 Ch_39 Ch_78 6,4 6,64 6,55 -88,5 -88,5 -88 6,26 6,55 6,48 -87,5 -88 -84 6. Mechanical Characteristics - Module dimension 40x17mm.
PAGE 3
7. Pin Description Pin No. 1 2 3 4 5 Pin Name 3D_sync VCC USB_DP USB_DN GND I/O I I I/O I/O - Pin Description Panel 3D sync signal 50/60 Hz VCC 5V USB Communication Signal USB Communication Signal Ground 8. Environmental 8.1. Operating Operating Temperature: 0 to 65 °C 8.2. Storage Temperature: -20 to 85 °C 9. Device Installation The module is a build in module. It will be used in-house production as an embedded device over USB 2.0 interface and there is no need any interaction with end-user.
PAGE 4
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Antenna connector port is not for use and disconnected at market products. Module is only allowed to use with the on board printed antenna. Vestel provides user notices in both English and French when the product is made available for sale and/or lease in Canada.