Install Guide BR35 Wireless Water Leak Sensor Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Document Document Details V1.0 (20211006) (V1.0 first published 20211006) Firmware Firmware version can be verified on Verkada Command command.verkada.com. 2 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Introduction What’s in the box 1x Wireless Water Leak Sensor 1x CR123A batteries What you’ll need ● ● ● ● ● 3 4x Screws 1x Adhesive Mounting Strip Connect BH61 Wireless Alarm Hub A working internet connection A smartphone or laptop #2 phillips driver (screwdriver or power drill) ¼ inch (6.35mm) drill bit if using wall anchors Please note: Add your BH61 Wireless Alarm Hub to Command before setting up your Wireless Water Leak Sensor. ● To register your product, please proceed to: verkada.
Introduction Sensor overview Base module LED Probe LED Behavior A green LED will turn on when water is detected. The light will stay on as long as water is still detected. When the sensor has a low battery, the green LED will flash rapidly three times every two minutes. 4 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Installation Mounting 1/2 The water leak sensor detects water via a probe with two metal contacts. Secure the probe in the desired location using the two screws. Remove the screw that connects the front cover and rear cover of the base module. Install the battery. Slide the front cover onto the rear cover and tighten the screw. 5 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Installation Mounting 2/2 Peel protective film from one side of the adhesive mounting strip. Adhere to the back of the base module. Peel the remaining protective film and adhere to the mounting surface. For best results, minimize physical obstructions between the base module and the Wireless Alarm Hub. 6 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Appendix BR35 Compliance FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Appendix Support Thank you for purchasing this Verkada product. If for any reason things don’t work right, or you need assistance, please contact us immediately. verkada.com/support Sincerely, The Verkada Team 8 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.