Install Guide BR34 Wireless Glass Break Sensor Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Document Document Details V1.0 (20211007) (V1.0 first published 20211007) Firmware Firmware version can be verified on Verkada Command command.verkada.com. 2 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Introduction What’s in the box 1x Wireless Glass Break Sensor 1x CR123A batteries What you’ll need ● ● ● ● ● 3 2x Screws 2x Wall anchors Connect BH61 Wireless Alarm Hub A working internet connection A smartphone or laptop #2 phillips driver (screwdriver or power drill) ¼ inch (6.35mm) drill bit if using wall anchors Please note: Add your BH61 Wireless Alarm Hub to Command before setting up your Wireless Glass Break Sensor. ● To register your product, please proceed to: verkada.
Introduction Sensor overview LED (Glow-through) LED Behavior A green LED will turn on when a glass break event is detected. The light will go off after five seconds. When the sensor has a low battery, the green LED will flash rapidly three times every two minutes. 4 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Installation Mounting 1/2 The glass break sensor detects glass break events within a range of 15 feet (5 meters). Ensure the sensor is mounted on a ceiling or wall at an appropriate distance. Push button to open the front cover. Secure the back plate to the mounting surface using the included screws and wall anchors. 5 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Installation Mounting 1/2 Install the battery. Close the front cover. For best results, minimize physical obstructions between the sensor and the Wireless Alarm Hub. 6 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Appendix BR34 Compliance FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Appendix Support Thank you for purchasing this Verkada product. If for any reason things don’t work right, or you need assistance, please contact us immediately. verkada.com/support Sincerely, The Verkada Team 8 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.