Install Guide AD32 Door Reader Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Document Document Details V1.0 (20220118) (V1.0 first published 20220118) Firmware Firmware version can be verified on Verkada Command command.verkada.com. 2 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Introduction What’s in the box AD32 card reader Mullion mount Single gang mount T8 security torx L key 2 Wall mount screws 2 Machine screws What you’ll need ● ● ● ● ● 3 A working internet connection A smartphone or laptop A #2 Phillips driver (screwdriver or power drill) 1/8 inch (3mm) drill bit for pilot holes 1/2 inch (12.7mm) drill bit, or larger, for routing cable through wall Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.
Introduction Sensor overview Status LED (Glow-though) LED Behavior Static white center Static white center Reader is active and ready for secure use. Green top bar Reader has successfully processed a user scan. Red top bar Reader has identified a negative read. Re-scan or investigate bad scan. 4 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Installation Wiring 5 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.
Installation Junction box mounting Loosen the security screw and remove the AD32 card reader from the mullion mount. Using the mullion mount as your template, mark and drill two holes. Drill 1/2 inch (12.7mm) hole into the mullion for cable routing if necessary. Route building-side cable through the circular opening in the mullion mount and secure the mullion mount to the mullion using 2 provided machine screws. Connect the wires using the table above or on the back of the AD32 module as reference.
Installation Mullion mounting Loosen the security screw and remove the AD32 card reader from the mullion mount. Route building-side cable through the opening in the single gang mount and secure the single gang mount to the junction box using 2 provided machine screws. Connect the wires using the table above or on the back of the AD32 module as reference. Insert the AD32 module into the single gang mount and secure using the T8 security screw and Allen key (provided). 7 Verkada Inc.
Installation Wall mounting Loosen the security screw and remove the AD32 card reader from the mullion mount. Using the mullion mount as your template, mark and drill two holes. Depending on your mounting surface you may need to drill pilot holes. If required, insert wall anchors now. Drill 1/2 inch (12.7mm) hole into the wall for cable routing if necessary.
Appendix AD32 Compliance FCC Statement This has been tested found comply with the limits for Class B digital device, pursuant to This equipment device complies with Part 15 and of the FCC to Rules. Operation is subject toathe following two conditions: Part 15 of the FCC Rules.
Appendix Support Thank you for purchasing this Verkada product. If for any reason things don’t work right, or you need assistance, please contact us immediately. verkada.com/support Sincerely, The Verkada Team 10 Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com All specifications are subject to change without notice Copyright © Verkada Inc. All rights reserved.