Installation Instructions

AD31 Overview

T10 Security

Torx screw

RFID, touch-less access

and status LED interface

Mount plate

Wiring cable

+1 (833) 837-5232

support@verkada.com

www.verkada.com/support

1.2

AD31 LED Behavior

White

Reader is active and ready for secure

badge entrance.

Green

Reader has successfully processed a

user scan.

Red

Reader has identied a negative read.

Re-scan or investigate bad scan.

AD31 Reader

What you’ll need

What’s in the box

• A working internet connection

• A smartphone or laptop

• A #2 Phillips driver (screwdriver or power drill)

• For non-Junction Box install:

• ⁄ inch (6.35mm) drill bit if using wall anchors

• ⁄ inch (3mm) drill bit for pilot holes

• ⁄ inch (12.7mm) drill bit, or larger, for routing cable through wall

• Wall mount screws & wall anchors (included)

1 AD31 Reader

1 Mount plate

2 Wall anchors, 2 wall mount screws &

2 junction box machine screws (6-32)

1 T10 Security

Torx Allen key

PAGE 1
AD31 Overview AD31 LED Behavior What you’ll need • A working internet connection • A smartphone or laptop RFID, touch-less access and status LED interface White Reader is active and ready for secure badge entrance. • A #2 Phillips driver (screwdriver or power drill) • For non-Junction Box install: • 1/4 inch (6.35mm) drill bit if using wall anchors • 1/8 inch (3mm) drill bit for pilot holes • 1/2 inch (12.
PAGE 2
AD31 Mounting 1. Route building-side cable through the circular opening in the Mount Plate. 2. Secure the Mount Plate to the junction box using 2 provided machine screws that match the junction box. 3. Connect the wires using the table on the adjacent page as reference. AD31 Wiring 1. Using the Mount Plate as your template, mark and drill two holes. Depending on your mounting surface you may need to drill pilot holes. If required, insert wall anchors now. 2. Drill 1/2 inch (12.