User's Manual

e Wireless Optical Mouse User Manual

ed wireless RF mice in our company, and it uses the global-used frequency of 27MHz. The comfortable and

bondage of wires and enjoy your beautiful life from the high technology.

many mice being used at the same time.

d scientific.

charge for the mouse. Even if there is no battery in the mouse, you can use the mouse directly, thus it resolve

atically, at this time, mouse begin to work. If you push the receiver back to the transmitter, power will be cut

The Steps of Install Battery

1, Please prepare for two PCS new AAA alkaline batteries

2, Press the button of the mouse upper cover and pull the battery cover rearward (Please see the referenc

3, Please insert the batteries correctly according to the polarity marks of the battery grooves.

4, Pull the battery covers forward, when you hear “crack” sound which shows the battery cover is locked s

Receiver Installation

1, please use extended cable, and put the receiver and transmitter on one desktop, in this way, you may ha

2, If you use PS/2 connector, please use the USB to PS/2 adaptor and connect with the connector before y

3, For laptop, you may connect the receiver directly with the USB connector.

ID Setup

1, Please move the mouse near to the receiver

2, Press the ID button of the mouse bottom with some hard and acuate object within 10 seconds, the re

successfully to finish the digital transmission between the mouse and the receiver. You may start to use

3. Working distance: within 0.6-1.5 m

PAGE 1
e Wireless Optical Mouse User Manual ped wireless RF mice in our company, and it uses the global-used frequency of 27MHz. The comfortable and e bondage of wires and enjoy your beautiful life from the high technology. The Steps of Install Battery 1, Please prepare for two PCS new AAA alkaline batteries 2, Press the button of the mouse upper cover and pull the battery cover rearward (Please see the referenc 3, Please insert the batteries correctly according to the polarity marks of the battery grooves.
PAGE 2
Any changes or modifications not expressly approved by the party responsible for compliance could v Note Note: This equipment has been tested and found to comply with the limits for a Class B digital device reasonable protection against harmful interference in a residential installation. This equipment genera accordance with the instructions, may cause harmful interfer- ence to radio communications.