Data Sheet

ManualsBrandsVeracity ManualsComputers & Accessories57V DC Power Supply

Ethernet and POE-over-coax to IP

cameras without the need to re-cable

HIGHWIRE Powerstar uses existing coax cable to connect and power

IP cameras without cabling costs. Easy to use and fast to install.

Re-use existing coax cable for IP cameras

Eliminate power cabling with POE-over-Coax

Reliably power POE Plus cameras (25watts)

Instantly check connection and power status with SafeView

Fully automatic - no conﬁguration required

Simple fast, cost-effective installation

Full 100Base-T Ethernet performance

ETHERNET & POE-OvER-cOax

IMAGINATION INNOVATION INTEGRATION DATASHEET

Summary of content (4 pages)

PAGE 1
I M a G I N AT I O N I N N O VAT I O N I N T E G R AT I O N d a t a s h eet E T H E R N E T & P O E - o v er - c o a x Ethernet and POE-over-coax to IP cameras without the need to re-cable HIGHWIRE Powerstar uses existing coax cable to connect and power IP cameras without cabling costs. Easy to use and fast to install.
PAGE 2
A true plug-and-play solution for connecting and powering IP cameras over legacy coaxial cabling Our unique ultra low-power design and reliable power delivery enables long range extension even over the lowest-grade cable, such as the high-resistance copper-clad steel (CCS) types found in many legacy installations.
PAGE 3
Once HIGHWIRE Powerstar is connected SafeView will automatically indicate POE power TM HIGHWIRE Powerstar adds the convenience of POE-over-Coax TM technology and gives you the reassurance of SafeView TM monitoring which displays the power available at the base unit without access the remote equipment. Simply add power power boost at either end of the cable, With no need to configure IP addresses, just connect the optional power supply.
PAGE 4
T ECHN I C A L S PE CI F I C AT I O N POWER Unit power 1.5 watts BASE POE In IEEE 802.3af (POE) or IEEE 802.3at (POE Plus), 2-event, power class 4 CAMERA POE Out IEEE 802.3af (POE) or IEEE 802.3at (POE Plus) DC Power input 40-57 volts, 0.7 amps maximum, class 2 isolated, detachable screw terminal HIGHWIRE INTERFACE Connector type BNC 75 Ohm Cable type Any 75 Ohm coaxial (other impedances supported) Range Up to 300m [1100ft] on RG59 or 500 metres [1600 feet] on RG11 at full rate.