User manual Under Cabinet Speaker Dock SPS3911 It is important to read this instruction book prior to using your new product for the first time. Il est important de lire ce manuel d’instructions avant d’utiliser l’appareil pour la première fois. Es importante que lea este libro de instrucciones antes de comenzar a usar su nuevo producto.
SAFETY INSTRUCTIONS FCC INFORMATION This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
POWER SUPPLY USING THE AC ADAPTER Using an AC adapter other than the one supplied with the unit may damage the unit. Caution: • Before use, ensure the rated voltage of the adapter matches your local voltage. • The included AC adapter is for use with this unit only. Do not use it with other equipment. • If you are not going to use the unit for a long time, disconnect the AC adapter from the wall outlet.
ACCESSORIES Please locate the included accessories. To order replacement units, visit www.RCAav.com. Remote control (with 2xAAA batteries)..............................x 1 AC power adapter...............................................................x 1 Mounting Screws (5x69 TM)..............................................x 4 Spacers 1.06” (27mm).......................................................x 4 Spacers 0.57” (14.4mm)....................................................x 4 Mounting Template........
MOUNTING INSTRUCTIONS TOOLS NEEDED: 1) Electric drill with 1/4” bit; 2) Phillips-head (cross style) screwdriver. STEP 1 If your cabinet does NOT have an overhang: a) Place the Mounting Template in the desired location inside or underneath the cabinet (whichever has less obstructions, and will be easier for you to reach to drill holes), flush with the front edge of the cabinet and tape it down. Go to STEP 2.
c) Hold the unit up against the bottom of the cabinet, and align the four holes on the top of the unit with the screws. Partially tighten each screw, but do not fully tighten the screws until all of them have been started. e) Partially tighten each screw, but do not fully tighten the screws until all of them have been started (see Figure 6). d) Gently tighten each screw until they are firmly holding the unit in place. If your cabinet DOES have an overhang: a) Four screws are included with this unit.
CONNECTION Plug the AC power adapter into the nearest wall outlet, and wrap the remaining cord around the cord storage knob at the rear of the unit. BLUETOOTH PAIRING Before Bluetooth pairing, you should turn on the Bluetooth function of your other device (such as, mobile phone with Bluetooth function). 1. Press SOURCE button on the unit or button on the remote control to select BT (Bluetooth) mode. The Bluetooth indicator light on the soundbar will blink. 2. On your device (mobile phone, MP3 player, etc.