User's Manual
RoHS
20 02/9 5/E C
FCC Statement
NOTE:
This equipment has been tested and found to comply with the Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connet the equipment into an outlet on a circuit different from that to which the receiver is connected.
3. Consum the dealer or an experienced radio/TV technician for help.
Note: Modiļ¬cations to this product will void the user's authority to
operate this equipment
Choice a location to place the repeater, make sure the repeater can receive the signal from
the transmitter (The LED indication will lit when receive a valid signal.). and the receiver will
receive the signal from the repeater.
When install more than one repeater need another special
caution, otherwise it will cause oscillation
USER MANUAL
Parts & Function
LED
indicator
Power
On/Off
DC6V
Battery Door
Setting
Installation
This unit do not need any setting, Just switch on the power
Hanging hole
Place the repeater middle of the transmitter
and receiver to extend the cover range.
Place the repeater on the corner
to eliminate the blind area.
Transmitter
Transmitter
Transmitter
Transmitter
Receiver
Receiver
ReceiverReceiver
Receiver
Repeater
Repeater
oscillation
X
X
Choice the location for repeater that does not inside the cover area of the other repeater.
The transmission range of the repeater cover another repeater. It cause oscillation.
RPX1000