User Manual
PIR lens
Power
Switch
LED indicator
Mounting backet
9V battery
(6F22)
Part & Function
Battery Installation
The PIR sensor works with the receiver (chime)
and must be paired before using
Step 1: Insert battery and switch on
the sensor.
Step 2: Insert batteries to the receiver
(chime).
Step 3: Enter pairing mode for receiver (chime
unit).
Press and hold the zone selector
button 3 seconds. The LED #1 will flash.
Step 4: Press the button again to move to
the zone you want to pair with.
Press melody selector to scroll
through the melodies. Once you hear
your preferred melody, do not press
again as it is now selected.
Step 5: Once you have selected the zone and
melody, trigger the PIR sensor once.
To trigger the sensor move your hand
across the lens.
If successful, the receiver will generate
a short tone. Press the button to exit
pairing mode, the system is now ready
to use.
Test the Sensor
Insert the battery and switch on the PIR sensor, it will start to detect
motion after 30 seconds. Walk to the front of the sensor within 8m.
Timer setting
5 seconds
5 minutes
User Manual
HAX-900
Pairing
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Note: Modifications to this product will void the user's authority to operate this
equipment.
Once the motion has been detected, the sensor will send out a
trigger signal to the receiver (chime) then go into a sleep mode for 5
seconds or 5 minutes. During this time it will not detect motion.
Switch off the sensor when not use.
PIR sensor effectivearea
8m
o
83
Top View Side View
8m
o
30
o
40
3m