User's Manual

+ +
The Entry Mat works with the receiver (chime or
vibrating pager) and must be paired before using
Step 1: Insert battery to the sensor.
Step 2: Insert batteries to the receiver (chime).
Step 3: Enter pairing mode for receiver (chime unit).
Press and hold the zone selector button 3
seconds. The LED #1 will flash.
Step 4: Press the button again to move to the zone
you want to pair with.
Press melody selector to scroll through the
melodies. Once you hear your preferred
melody, do not press again as it is now
selected.
Step 5: Once you have selected the zone and melody,
trigger the Entry Mat with step on the mat
If successful, the receiver will generate a
short tone. Press the button to exit pairing
mode, the system is now ready to use.
CODE CONFLICT
If the entry mat sensor coding is same as another sensor. you must
change the code of the entry mat sensor .
CODE MATCHING AND MELODY SELECTION
ENTRY MAT SENSOR
BATTERY INSTALLATION
OPERATION
PARTS & FUNCTION
Sensor
Sensor pocket
Transmitter
Mat
Battery Compartment
+ +
1. Take out the transmitter from the sensor pocket
2. Open the battery with a small screwdriver
3. insert 2 CR2032 to Battery compartment.
4.Close the battery cover and put the transmitter to the sensor pocket.
1. Take out the transmitter from the sensor pocket
2. Open the battery with a small screwdriver
3. Take out 2 CR2032 from Battery compartment.
4.Step on the mat and install the batteries again.
The LED will flash 5 times when a new code is generated
ID
Zone selector
button
Melody
selector
Put the entry mat in the entrance. Put a rugon the top of theentrymat to
protect the mat sensor.
The sensor will transmit a trigger signal to the receiver when someone
step on the mat.
BATTERY LOW INDICATOR
The status of sensor battery is indicate on the receiver. Please refer
to the " battery low indicator" on the receiver.
FCC Statement
Note:This equipment has been tested and found to comply with the Part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment of
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connet the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consum the dealer or an experienced radio/TV technician for help
Note: Modifications to this product will void the user's authority to operate
this equipment.