User Manual

FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Note: Modifications to this product will void the user's authority to operate this equipment.
Slide the switches inside the battery cover for your needs.
1. Power .
Switch to off position when do not use this device.
2. Transmitter On/Off switch .
On : Send a trigger signal to receiver when triggered
Off : Do not send signal to receiver when triggered.
3. Sound selector
Select the suitable sound by slide this switch to or position
4. Light On/Off
Turn the flash light on or off by slide this switch.
5. Volume control :
You can select High II / Low I / No sound by slide this switch.
6 Regenerate a new code :
If the RF code is conflict, press the button in the pin hole to regenerate a new code
USER MANUAL
HAX-700
PWR
PWR
TX
TX
SND
SND
LIGHT
LIGHT
On
Off
On
Off
On
Off
On
Off
ReCode
ReCode
A
A
On
Off
On
Off
B
B
Mode Sound
Mode Sound
Hi
Lo
Off
Hi
Lo
Off
NO
NC
3S
NO
NC
3S
Parts and Function
9
10
12
13
14
15
11
1. Batteries compartment
2. Battery Door
3. Regenerates new code button.
5. Transmitter On/off switch.
6. Alert sound selector.
Power
+
Remove the screw
and slide to open
the battery cover
Flip to open the cover Insert 3 AAA bateries to
the battery compartment
and close the battery cover
Setting
7. Light on/off switch.
8. Volume control.
9. Sensor input jack
10. Anti-take off Cover
11 Cover lock
Installation
Sensor Plug
Unlock
lock
Unlock and slide out the
cover to plug in the sensor
12 Flasher
13. Speaker
14 LED indicator.
15. Magnetic holder
PWR
TX
SND
LIGHT
On
Off
On
Off
ReCode
A
On
Off
B
Sound
Hi
Lo
Off
1
2
3
4
6
7
Pairing with receiver
This unit can work stand alone or work with the wireless receiver. If work with the receiver, you
need to pairing with the receiver follow to the manual of the receiver.
+
+
31.5mm
Operation
Using the rope attach to the object that
you do not want other people move it
Once the magnetic is out of position, the alarm
will acticvated
R
R
R
II
I
1
2
3
4
5
6
7
8
R
II
I
A
AA
AA
A
A
AA
R
II
I