User Manual

CODE MATCHING AND MELODY SELECTION
PARTS & FUNCTION
BATTERY INSTALLATION
ID
Zone selector
button
Melody
selector
CHI ME
LIG HT
LIG HT & CHIM E
R
E
SE
T
Back Holder
Mounting Holes
Reset
Battery Cover
Battery Compartment
LED
Pull
Handle
+
+
+
Remove the
battery cover
Replace the
battery cover
Insert a 12V battery
23A
The Pull Station works with the receiver
(chime) and must be paired before using
Step 1: Insert battery to the sensor.
Step 2: Insert batteries to the receiver (chime).
Step 3: Enter pairing mode for receiver (chime
unit).
Press and hold the zone selector
button 3 seconds. The LED #1 will flash.
Step 4: Press the button again to move to
the zone you want to pair with.
Press melody selector to scroll
through the melodies. Once you hear
your preferred melody, do not press
again as it is now selected.
Step 5: Once you have selected the zone and
melody, trigger the pull station by
pulling the handle.
If successful, the receiver will generate
a short tone. Press the button to exit
pairing mode, the system is now ready
to use.
INSTALLATION
TEST THE SENSOR
Pull the handle to test the pull station after installation.
The LED on the toilet pull will lit up 1.2 second to
indicate it is transmitting.
The unit will keep transmission every 1.3 seconds until
release the handle.
o
/ 7mm
25mm
Mark 4 holes on
the celling using
a pencil
Requires an electric drill for holes to fix the Sensor with the provided
ram plug and screws.
+
+
+
+
+
+
+
+
R
E
SET
R
E
S
E
T
R
E
S
E
T
Mount the unit to the
celling.
TYPICAL LOCATION
Alongside the WC
Set upper handle
800-1000mm from floor
Set lower handle
100mm from floor
100mm
800mm
CANCELLING THE ZONE INDICATOR
You can press the 'reset' button on the pull station to
deactivate the zone indicator on the receiver. You can
also press the 'reset' button on the back of the receiver
to deactivate the zone indicator.
UserManual
FCC Statement:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to
operate this equipment.