User's Manual

Battery Installation
Code Matching & Melody Selection
LED indicator
Reset Code
Button
Parts and Function
Align mark
Battery
compartment
Battery cover
Open battery cover
Insert the CR2032 battery
Magnet
The magnetic sensor works with the receiver (chime)
And must be paired before using
Step 1: Insert batteries to the
sensor.
Step 2: Insert batteries to the
receiver (chime).
Step 3: Enter pairing mode for receiver
(chime unit).
Press and hold the zone selector
button 3 seconds.
The LED #1 will flash.
Step 4: Press the button again to move to the zone you want to
pair with.
Press melody selector to scroll
through the melodies. Once you hear
your preferred melody, do not press
again as it is now selected.
Step 5: Once you have selected the zone and melody, trigger the
magnetic sensor by holding the sensor and magnet
together, then move them apart.
If successful, the receiver will generate a
short tone. Press the button to exit
Pairing mode, the system is now ready to
use.
Installation
Operation
Install a CR2032 batterн to the battery compartment.
Stick the double sided tape on the back of the alarm unit, then
remove the back paper of the double sided tape.
Stick the alarm unit to the window/door frame and the magnet unit
to the door/window by the side of the alarm unit..
USER MANUAL
When the magnet moves away from the
sensor unit, the sensor send out a signal to
the receiver (chime).
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to operate this
equipment.
HAX-120
Code Conflict
If the transmitter coding is the same
as another transmitter you must
change the code. When you have
c hange d t he c o de r e - pair t h e
transmitter is needed.
+
Press and hold 3
seconds to reset
the code using a
pen.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS