User Manual

FCC Statement:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifications to this product will void the user's
authority to operate this equipment.
PARTS & FUNCTION
MOUNTING
Or
Hang on the wall
Clip on Belt
POWER
Using 2 x AA size Battery
Reset
Speaker
ID
Reset
Melody
selector
Zone select
button
Belt Clip
Function switch
Vibration &
Melody
Melody
Vibration
OPEN
OPEN
Battery Compartment
Reset
Reset
1. Slide to open the battery
cover
2. Insert 2 AA batteries
3. Close the battery cover.
First, press and hold the button for 3 seconds to enter the pairing
mode. Press the button to move to the zone which is to be
deleted. Press and hold the and buttons together for 3
seconds.
The receiver will generate a tone to indicate the transmitter on this
zone has been deleted.
First, press and hold the button for 3 seconds to enter the pairing
mode. Press the button to move to the zone then press the
button to select the melody required. Press the button until the
pairing mode is exited.
Step 1: Insert battery to the transmitter to be used e.g.door bell.
Step 3: Enter pairing mode for
receiver (pager unit).
Press and hold the zone select
button for 3 seconds.
The LED #1 will flash.
Step 4: Press the button again to move to
the zone you wish to pair with.
Press melody selector to scroll
through the melodies. Once you hear
your preferred melody, do not press
again as it is now selected.
Step 5: Once the zone and melody are selected with the zone icon
flashing, trigger the transmitter once to pair. If successful,
the receiver (pager) will generate a short tone. Press the
button to exit pairing mode, the system is ready to use.
CODE MATCHING & TUNE SELECTION
Clear the transmitter on the Pager memory
Change the melody in desired zone
Battery low indicator
If a zone LED light is blinking, it indicates that the battery is low for
this transmitter. You must replace the battery as soon as possible.
If the Pager beeps every 5 seconds, this indicates the Pager
batteries are low. You must replace the batteries of the Pager.
To stop the Vibrating Pager whilst it is alerting press the reset button
USER MANUAL