Owner's Manual
model: ACC-TSENWIFIMINI
Wireless Temperature Sensor
Installation Instructions
Before you begin the installation:
The Venstar Congurator App is needed to congure this sensor.
This App may be downloaded from your mobile device store.
Select a suitable location for the ACC-TSENWIFIMINI sensor. Please
note that the sensor must have good Wi-Fi reception with the access
point it is intended to join. Do not mount in direct sun or direct rain.
Please have handy the Owner’s Manual for the thermostat that will
be paired with the sensor. Venstar thermostats have unique pairing
procedures.
OVERVIEW
This wireless temperature sensor may be used as a room remote temperature sensor or an outdoor temperature sensor.
Venstar thermostats vary by model in the way they can use remote sensors. This includes averaging, control to, or monitoring features.
Please consult the Owner’s Manual of the thermostat that you are going to pair this sensor with to understand its capabilities and
pairing procedure.
This sensor is compatible with most Venstar Wi-Fi thermostats that contain the latest rmware. Please consult Venstar.com for a complete
listing of compatible thermostats.
Note: This sensor must be connected to the same local network as the thermostat(s) that will use the sensor data.
Congurator
app icon
g. 1
Unit ID
Legend
g. 2
To Connect the Sensor to an Access Point:
1. Remove sensor cover.
2. Congure the Sensor. (use g. 2 as a guide)
A Set the Type:
1. Indoor temperature is sampled and transmitted once every minute.
2. Outdoor temperature is sampled and transmitted once every 5 minutes.
B Set the Unit ID:
If more than one ACC-TSENWIFIMINI is joined to an access point
each sensor must have a unique UNIT ID# to operate properly.
Add all of the ID ’ON’ switches together to arrive at the Unit ID#.
If all the ID number switches are set to ‘OFF’ then the Unit ID# is 0 (zero).
Up to 8 ACC-TSENWIFIMINI sensors may be joined to one access point.
A
B
ON
OFF
124
Example: Unit ID# 5
1 + 4 = 5