Owner's Manual

ManualsBrandsVenstar ManualsElectronicsBLE/SubGig Temperature Sensor

model: ACC-VNTH1

Wireless Temperature/Humidity Sensor

Installation Instructions

OVERVIEW

This wireless temperature sensor may be used as a room remote temperature sensor or an outdoor temperature sensor.

When used as an outdoor sensor it must be kept out of direct rain and sunlight.

Venstar thermostats vary by model in the way they can use remote sensors. This includes averaging, control to, or monitoring features.

Please consult the Owner’s Manual of the thermostat that you are going to pair this sensor with to understand its capabilities.

This sensor is compatible with Venstar VenNet thermostats that contain the latest rmware.

If you are wanting to pair this sensor to a thermostat other than what is depicted in these instructions,

please scan the QR code or look on venstar.com/support/accessories/vennet-temp-hum-sensor-support/

for pairing instructions and a list all compatible thermostats.

ﬁg. 1

SPECIFICATIONS

Temperature Measurement Range:

-40°F - 130°F

Humidity Measurement Range:

0 – 100% RH

Temperature Sample rate

Once a minute

Expected Battery Life - Type CR2450

• Remote Sensor sample rate of 1per minute: > 1 year

TO PAIR THIS VenNet SENSOR TO A THERMOSTAT:

1. Make sure a fully charged CR2450 battery is installed in the

sensor as shown in Fig. 1.

PULL BACK TO

REMOVE BATTERY

PRY HERE WITH

FINGER TO REMOVE

BATTERY

How to remove

the sensor cover

1. REMOVE THIS TAB.

2. HOLD SENSOR NEAR

STAT, PRESS BUTTON

FOR 2 SECONDS.

3. FOLLOW THE

INSTRUCTIONS

ON STAT.

TO PAIR:

Before initial use pull this

mylar tab out from under

the battery

Note: Extended extreme temperatures may have a negative impact on range and battery life.

Use phone camera

for more info

Summary of content (4 pages)

PAGE 1
ACC-VNTH1 Wireless Temperature/Humidity Sensor model: Installation Instructions OVERVIEW This wireless temperature sensor may be used as a room remote temperature sensor or an outdoor temperature sensor. When used as an outdoor sensor it must be kept out of direct rain and sunlight. Venstar thermostats vary by model in the way they can use remote sensors.This includes averaging, control to, or monitoring features.
PAGE 2
. Press and hold the Pair Button on the sensor for 1 second, Fig. 2. a. Upon release of the Pair Button the LED will flash twice. b. The sensor will remain in its pairing state for 1 minute. 3. Move the sensor next to the VenNet thermostat to be paired, within 3 inches of the thermostat. 4. The thermostat will recognize the sensor and display NEW SENSOR IS DETECTED, fig 3. PUSH TO PAIR Press WARMER to pair the sensor to the thermostat. a. The thermostat will display PAIRING. fig. 2 b.
PAGE 3
INDOOR SENSOR MOUNTING CONSIDERATIONS: • The sensor must be mounted within communication range of the thermostat it is paired to - Typically, the range is 250 feet in “clear air” with no obstructions such as walls - The range will be reduced by walls, furniture, appliances, and other obstructions • Generally, the sensor should be mounted ~5 feet above the floor on insulated, interior walls • Do not mount the sensor: - Next to windows - In direct sunlight - In the direct airflow of an air supply - Next
PAGE 4
Warranty One-Year Warranty - This Product is warranted to be free from defects in material and workmanship.