User's Manual

Table Of Contents

Patent Pending

P/N 88-811 Rev. 3

S1-LXRFM LX SERIES THERMOSTAT RF MODULE FEATURES:

Compatible with these thermostats:

Installation

Install the Thermostat RF Module.

S1-LXRFM

Thermostat RF Module

Front Housing

Backplate

Finger Pull Areas

To remove the thermostat backplate:

Using the Finger Pull Areas, pull the front housing

away from the backplate.

Remove the thermostat Backplate.

Line up the Guide Pins on the Thermostat RF

Module with the holes on the printed circuit board.

Push gently until the Thermostat RF Module lays

flat against the board.

THERMOSTAT RF MODULE

2-way wireless communication

Links wireless sensors and accessories to the thermostat

Frequency hopper to avoid interference

Easy, 2 minute installation

S1-THSU21P1_, S1-THSU32P7_, S1-THSU32HP7_,

S1-TBSU22HN_, S1-TBSU32P7_, S1-TBSU32HP7_

Consult Source 1 for a complete list.

GUIDE PINS

Make sure to remove the Thermostat RF Module

port cover before installation.

PAGE 1
S1-LXRFM Thermostat RF Module S1-LXRFM LX SERIES THERMOSTAT RF MODULE FEATURES: 2-way wireless communication Links wireless sensors and accessories to the thermostat Frequency hopper to avoid interference Easy, 2 minute installation Compatible with these thermostats: S1-THSU21P1_, S1-THSU32P7_, S1-THSU32HP7_, S1-TBSU22HN_, S1-TBSU32P7_, S1-TBSU32HP7_ Consult Source 1 for a complete list. THERMOSTAT RF MODULE Installation Remove the thermostat Backplate.
PAGE 2
THERMOSTAT RF MODULE S1-LXRFM Linking and Viewing Wireless Devices Press the LINK button or the button designated for linking on the wireless device. Press the ACCSRY button on the thermostat to enter the Accessory setup screen. (see illustration below) Press the COOLER button to enter accessory linking mode or press WARMER to view linked accessories. 4 If COOLER is pressed, press the MODE button to initiate accessory linking. The thermostat will attempt to link to the wireless device for 5 minutes.