User Manual

ManualsBrandsVendor Brand ManualsGazebosGazebo, 10 x 10-ft

IMPORTANT:

Please read and follow all safety statements, warnings, assembly instructions, use & care

directions before attempting to assemble. Please take down the gazebo during strong

wind. The manufacturer or retailer is not liable for any loss of the product or other items

due to the failure to take down the gazebo during strong wind.

WARNINGS:

1. Assembly Instructions must be followed.

2. Pegs supplied must be used to hold this gazebo in place when upright.

3. Do not use candles, matches or open flames of any kind in or near a tent.

4. Do not cook inside the tent.

5. Build campfires downwind and several meters away from a tent and be sure to fully

extinguish campfires before leaving a campsite or before retiring for the night.

6. Exercise extreme caution when using fuel-powered lanterns or heaters inside a tent and use

battery-operated lanterns whenever possible.

7. Do not refuel lamps, heaters or stoves inside a tent.

8. Extinguish or turn off all lanterns before going to sleep.

9. Do not smoke in a tent.

10. Do not store flammable liquids inside a tent.

11. KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent is

made of flame-resistant fabric. It is not fireproof. The fabric will burn if left in continuous contact

OWNER’S MANUAL

10x10 SUN SHELTER WITH NETTING

L-GZ512PST-C

299-4560-2

Summary of content (6 pages)

PAGE 1
OWNER’S MANUAL 10x10 SUN SHELTER WITH NETTING L-GZ512PST-C 299-4560-2 IMPORTANT: Please read and follow all safety statements, warnings, assembly instructions, use & care directions before attempting to assemble. Please take down the gazebo during strong wind. The manufacturer or retailer is not liable for any loss of the product or other items due to the failure to take down the gazebo during strong wind. WARNINGS: 1. Assembly Instructions must be followed. 2.
PAGE 2
with a flame source.
PAGE 3
Tools required: ladder, hammer, screwdriver (not included) Fig.1: Insert both ends of short support pole ( 4 ) into long support pole ( 3 ), then insert the other end of long support pole ( 3 ) into 90 degree angle tube of corner connector ( B ), make sure the sloping pipe upward. Fig.
PAGE 4
Fig.4: Insert one end of upper pole (1) with spring into corner connector (B). Fig.5: Insert the end of lower pole ( 2 ) with shrink tube into upper pole (1), insert the other end of lower pole (2) into base (A), then use stake (AA) through base (A) to fix the gazebo.
PAGE 5
Fig.6: Hook the metal buckle at the lower end of big canopy (E) to the hole of lower pole (2), then attach plastic buckle to the hook of base (A) as shown in Fig. 6. Fig.7: Expand big canopy ( E ), tie rope ( BB ) to the four corners of the gazebo, reinforce it using rope peg ( CC ), finally attach plastic ring (DD) to mosquito netting (F) , hang to long support pole ( 3 ) or short support pole ( 4 ) as shown in Fig. 7.
PAGE 6
USE & CARE: 1. This gazebo is not a permanent structure and should be disassembled & stored away after use. 2. Do not repack your gazebo until completely dry. 3. In order to reduce the risk of personal injury and damage to equipment, basic safety precautions should always be followed when assembling and using this product. Read all instructions carefully before assembly and use. 4. Some parts may contain sharp edges. Wear protective gloves if necessary.