Installation Instructions

ENGLISH:
IMPORTANT INFORMATION
WARNING – TO REDUCE THE
RISK OF SEVERE INJURY OR
DEATH:
Read instructions carefully before installation and operation. Keep instructions for future reference and hand
them over to any new user.
Electrical connection
It is customer's responsibility:
• To contact a qualified electrical installer.
• To assure that the electrical installation is adequate and in conformity with National Electrical Code,
ANSI/NFPA 70 - latest edition*, and all local codes and ordinances. Failure to do so could result in fire, electrical
shock, other serious personal injury or death.
• Do not connect power to the VELUX INTEGRA® control unit KLC 410 until the installation of the Modular
Skylight and roller blinds is completed and they are ready for registration in wall switch KLI 311/312 or in a
potential-free switch. See page 5.
• Disconnect power to the skylight during installation to prevent
the Modular Skylight from opening or closing suddenly and uncontrollably.
Electrical Shock Hazard
• The VELUX INTEGRA® control unit KLC 410 is a class I product.
• Disconnect power to control unit before servicing the skylight.
• Do not have a fuse in the neutral circuit. This could result in a fire, electrical shock or other personal injury.
• Do not install the control unit and the Modular Skylight in a location or at a height were unsupervised
children may be present.
• Always switch off power to the control unit at the service panel when connecting the control unit, when
connecting the skylight, when installing accessories and whenever the control unit cover is removed.
• On suspicion of malfunction, switch off power and call for service.
Safety
• The skylight can when connected to the control unit be used by persons (aged 8 years and above) with
sufficient experience and knowledge if they have been given instruction concerning its safe use and understand
the hazards involved. Cleaning and user maintenance must not be made by unsupervised children.
• Children must not play with the skylight and its electrical products. The control should be kept out of reach of
children. Do not allow children near an open skylight.
• Before operating ensure that the skylight with electrical products can be operated without risk of damage to
property or injury to people or animals.
• For personal safety, never have head, hand, arm or any other body part out of or through the opening of the
skylight without first having switched off power.
• If repair or adjustment work is needed, disconnect power and ensure that it cannot be reconnected
unintentionally.
• It is recommended that a control be placed in the room where the skylight and its electrical products have
been installed.
• Control unit: FCC ID: XSG863765 and IC ID: 8642A-863765.
• This device complies with part 15 of the FCC and RSS-210 of the IC rules.
Commented [MRL1]: Vi plejer ikke at tage det med, men
det OK med os, hvis du syntes det er nødvendigt (Vi plejer
altid bare at kalde det Control unit KLC 410).
Commented [MRL2]: Tilføjes her når der er tale om det
enkelte modul