TR707+ UHF Transceiver A Member of the BWIN™ Family of Products INTALLATION AND OPERATION GUIDE
Document: Approved: tr707_ml_r01_sd G.V. Proprietary to Vecima Networks Inc. All rights reserved. No part of this publication may by reproduced in any form or by any means or used to make any derivative work (such as translation, transformation or adaptation) without written permission from Vecima Networks Inc. Vecima Networks Inc. reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of Vecima Networks Inc.
SAFETY PRECAUTIONS 1. Before installing and operating this equipment, read all Safety, Installation and Operating sections. Retain this manual for future reference. 2. Follow all instructions — Failure to do so may result in damage to the unit or severe personal injury. 3. Servicing should not be attempted by the user. There are no user serviceable parts inside. Refer all servicing to factory qualified personnel. 4.
INDEX 1.0 GENERAL INFORMATION......................................................................................................... 1 1.1 Functional Overview ............................................................................................................................... 1 1.2 Module Features ...................................................................................................................................... 1 1.3 Specifications .............................................
1.0 GENERAL INFORMATION 1.1 Functional Overview The Vecima Networks TR707+ is a subscriber transceiver for use in wireless systems. The TR707+ and antenna are situated outdoors and connected to a cable modem indoors by standard RG-59 cable. A single RF connector on the weatherproofed enclosure provides the interface to the transmit/receive antenna for rapid setup. The transceiver is configured to work with standard cable modem frequency plans and levels, permitting direct connection.
1.3 Specifications TRANSMITTER SPECIFICATIONS IF Input Frequency RF Output Frequency Linear Output Power Output P1dB Spectral Mask Gain Gain Flatness (Frequency Response) Gain Stability Phase Noise IF Level for RF Activation RF Activation Response Time 24-42 MHz 698-716 MHz +24 dBm QPSK +24 dBm 16QAM +27 dBm FCC CFR 47 Part 27.53 18 ± 2 dB at 20°C ± 1.
2.0 INSTALLATION 2.1 Unpacking the Unit Carefully remove the equipment from its packing material and set it on a solid surface, such as a table or desk. If it appears damaged in any way, notify the carrier, and keep all packing materials for inspection by the carrier’s agent. 2.2 Mounting the Unit 2.2.
( Included with the TR707+ unit is a self-adhesive label for application to the antenna. To operate the TR7007+ in compliance with FCC regulations, you must apply the included label to the antenna. Peel off the protective backing from the label and affix it to the antenna such that the label is readable from a distance of 5 feet. DIAGRAM 2.2C: APPLYING THE SELF-ADHESIVE LABEL tr707_ml_r01_sd Approved: G.V.
2.4 Connection to the Antenna Connect the TR707+ to the Antenna via the F-Connector DIAGRAM 2.3A: CONNECTION TO THE ANTENNA tr707_ml_r01_sd Approved: G.V.
2.4 Connection to the Power Inserter and Cable Modem Connections to the TR707+ are made as shown in Diagrams 2.3A and 2.4A. The power inserter has three connections: DC POWER Connect to wall adapter with RG-59 cable with F connectors TO MODEM Connect to cable modem TO TRANSCEIVER Connect to TR707+ WARNING! If the power inserter is not connected correctly, the TR707+ will not operate, and there is the potential to damage the cable modem.
2.5 Waterproofing Connections Many transceiver problems can be attributed to environmental conditions (including vibration), which can loosen cables and permit moisture to penetrate the connectors. It is highly recommended to seal the connectors using a technique similar to the one described below. This will provide moisture protection and keep the connections tight.
4.0 WARRANTY STATEMENT AND SERVICE POLICY 4.1 Warranty Statement Vecima Networks warrants its products to be free from defects in workmanship or materials for a period of two years. The warranty begins on the date of the original shipment from Vecima Networks to its customer. No claim may be allowed for expenses incurred in installation or use. No other expressed or implied warranties shall apply to the goods sold.
4.3 Repair Charges and Warranty Exemptions Items returned beyond the warranty period or items that do not qualify for warranty service are subject to additional out-of-warranty repair charges. Descriptions of these charges and warranty exemptions are below: 1) Repair turnaround time is typically 5-14 business days after receipt of the item at Vecima Networks. A Flat Rate Repair Charge will apply to all out-of-warranty items. Flat Rate Repair Charges are subject to change without notice.
150 Cardinal Place Saskatoon, Saskatchewan, Canada S7L 6H7 Tel: (306) 955-7075 Fax: (306) 955-9919 Web: www.vecimanetworks.com Email: sales@vecimanetworks.