D. Setting Up System To enjoy wireless video and adieu, just connect the transmitter (Model GN200 or GN201) fo whatever audio/video source you want to enjoy from another location, and connect the receivership or GN301) to the TV, monitor or powered speakers in that other location. RE Receiver (GN300 or GN301) Sat-Receiver } Tv my ver si orl (GN201.GN301 PC Camcorder only) LI. | Nell re 2.4GHz = and mare...
[J How To Transmit Audio/Video from Your Satellite Receiver ‘You can transmit audio/video either directly from your satellite receiver, or by connecting them to your VCR. To transmit directly from your satellite overtire, follow the instructions below. 1. Connect one set of audio/video (A/V) cables (or scary cable labored "TRANSMITTER" to the A/V jacks of the transmitter (GN200 or GN201) and to the AUDIOVISUAL OUT jacks (or scary connector) of the satellite receiver or laser disc player.
Panel Controls and Features The following illustrations show the names of each components, button and switch connectors on the transmitter and receiver, FRONT VIEW FOR GN200 AND GN300 Directional 2.4GHz antenna sends or receives audio and video signals. Channel selection button Channel indicator lights us to find optimal ust be set to ion, ect m set to same cep " pos py umber on both .
£7] Connecting Receiver to Remote TV through VCR This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the picture and sound on a remote TV at the same time. 1. Connect one set of audio/video (A/V) cables to the A/V output jacks of the receiver (GN300 or GN301) and to the A/V input jacks on your VCR. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the system receiver and the VCR.
c.IR extender to connect to tans miter's rear panel x1 d fasten strips X2 C. Panel Controls and Features The following illustrations show the names of each components, bunion and switch connectors on the transmitter and receiver.
REMOTE ANTENNA CONTROL on ONLY) ANTENNA Corp ™ (tonal ONLY} ANTENNA CURVE™" f1 (GNARL ONLY] spe TRANSMITTER (roe View) RECEIVER (Freon View} ANTENNA CONTROL Fig-2: Fig-3: Orienting the Remote Control Antennas (GN201 and GN301 only) In order to obtain optimal performance of the remote control extender, the remote control extender, the remote control antennas should alas be oriented at a right angle to an imaginary line drawn between the transmitter and receiver units, TRANSMITTER ANTENNA.
A. Introduction to 2.4 GHz Wireless Video Sender F. Using the Remote Control Feature (GN201 and GN301 only The system is a wireless audio/video sender that uses advanced wireless communication technology to deliver consistently sharp audio and video up to 300 meters away. By transmitting at a very high frequency (2.4 GHz or 2.4 billion cycles per second), the BET-compliant The system avoids the crowded 900 MHz band used by many cordless telephones and other wireless audio/video transmitters.
G. Troubleshooting, Care and maintenance Please read this owner's manual carefully and follow the steps described in it. If you still have difficulties, consult the following table. It will guide you though the most common problems and their solutions.
[] Important-Safety Precautions + To prevent fire or shock hazard, do not expose this product to rain or moisture. Do not use near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool. + To avoid electrical shock, do not open this product. » This product should be operated using only the power supply included with it or provided as an accessory. + Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.