Full Product Manual

Package Contents
1. Frame.
2. Door leaf.
3. Fixing anchors - 6 pieces (or more - optional, depends on the design and
model of the door).
5. Door handles, cylinder, cylinder covers, keys, plugs - 6 pcs. (delivery set
depends on design and model of door). If necessary mounting brackets to be
purchased separately.
Installation rules for the door unit
Installation of the door unit shall be performed by trained and qualified
personnel.
Doors may not be installed during or before renovation work (plastering,
painting, wallpapering, tiling, etc.) and for three days after completion.
We recommend installing the door unit in the outer wall of the house to make
behind a wooden (plastic, aluminum) door. This, in most cases helps to avoid
condensation on the inside of the metal door in the fall and winter and protect
the outer surface from the effects of ultraviolet light and precipitation. If the
door unit is installed as an entrance from the street, it is necessary to provide a
canopy to protect the door unit from heavy rainfall, as well as the presence of a
cold vestibule.
As a door unit used as an entrance from the street to the living space, only
models with weatherproof finish are allowed, in which, with proper installation
and arrangement of warm lining in normal operating conditions (humidity,
temperature, the presence of ventilation in the premises) minimizes the
appearance of condensation on the inside and, consequently, frostbite in winter.
It is not recommended to install the door as an entrance door from the street
without a cold, ventilated vestibule at least one meter deep on the inside to
eliminate the possibility of condensation or hoarfrost forming on the various
parts and mechanisms of the door during the cold season.
Before installing the door unit it is necessary to:
- Check that the dimensions of the opening are correct. The opening must be
0..5-1 inches larger than the installation size of the door unit on each side to
ensure installation clearances;
- Check the door unit and hardware set for defects;
- Clean the opening from any encrustation of mortar and concrete, debris, dust,
and dirt (in winter - ice, snow, and hoarfrost). In reconstructed and repaired
buildings - from the remnants of the dismantled door frames and caulk;
- install the handle(s): install the square in the square hole of the lock with the
matching grooves of the square and the threaded holes of the handle; put on the
handle and fix it on the square with the locking screws;