Installation & Assembly

ManualsBrandsVaxcel ManualsLightingWhitney Textured Black 16.75'' H Seeded Glass Outdoor Armed Sconce with Dusk to Dawn

Assembly Kit

(1 SET)

(4578MM)

Glass Panel

(4 PCS)

(9363S)

Fixture

1. Thread two fixture mounting screws to the cross bar, and secure them with two lock nuts. Adjust

the length of the fixture mounting screws if necessary.

2. Attach the cross bar to the outlet box by using two mounting screws.

3. Install glass panels.

a. Gently place a glass panel into the inside of metal frame and make certain side of glass panel

sits at inside groove.

b. Repeat with other glass panels.

4. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections

using the wire nuts:

---Connect the black wire from the fixture to the black wire from the power source.

---Connect the white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect it

to the house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

5. Attach the back plate to the cross bar by inserting the fixture mounting screws, then secure it with

rubber pads and ball nuts.

CAUTION: With silicone caulking compound, caulk completely around where the back plate

meets with the wall surface to prevent water from seeping into the outlet box.

Rubber Pads

Bulb Type A Max.60W

(not included)

Ball Nut

Dome

Set Screw

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Rubber Pads

Glass Panel

Metal Frame

Back Plate

House Grounding Wire

Green Grounding Screw

Fixture Grounding Wire

Wire Nut

Mounting Screw

Outlet Box

Fixture Wire

Lock Nut

Cross Bar

Fixture Mounting Screw

Nipple

Finial

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0168

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

170821

Hardware Package (included):

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0168 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
6. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage. 7. Attach the finial onto the dome, then secure it with the nipple. 8. Attach the dome to the metal frame by using two rubber pads and set screws. 9. Turn on the power at the main fuse or circuit breaker box.