Installation Guide

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Hardware Package (included):

Mounting Screw (B)Cross Bar Unit (A)

Wire Connector (C)

T0610

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Max.60W Type A Bulb

(not included)

Fixture

Holder

Socket

Metal Cover

Metal Frame

Bolt Nut-a

Shade

Socket Ring

Photocell

Wire Connector (C)

House Grounding Wire

Outlet Box

Mounting Screw (B)

Green Grounding Screw

Headless Screw

Cross Bar Unit (A)

Fixture Wire

Rubber Pad

Backplate

Bolt Nut

Fixture Grounding Wire

Cage Screw

Bolt Nut-a

Fig.

211206

PAGE 1
T0610 ASSEMBLY AND INSTALLATION INSTRUCTIONS W WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box. 1. Unscrew the two bolt nuts, remove the two rubber pads and the cross bar unit (A) from the backplate. 2. Attach the cross bar unit (A) to the outlet box by using two mounting screws (B). 3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows: • Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
PAGE 3
. Take a white pigtail and black pigtail and make wire connections using wire connectors (C): (See Fig.3) a. The black wire from the fixture to one end of the black pigtail. b. The white wire from the fixture to one end of the white pigtail. c. The other end of the black pigtail to the black wire from the power source. d. The other end of the white pigtail to the white wire from the power source. Put all wires back into the back plate of the fixture. Turn on the power at fuse or circuit box.