M10 Pro and M10 Lite User Manual M10 PRO AND M10 LITE Hardware User Manual Product Version: 1.0 Date: 2021-1-7 For any question, please contact Chengdu Vantron Technology, Ltd. Copyright © Vantron Technology, Ltd. All rights reserved.
Change History This table describes the version and release date. Rev. Date Description Author 1.0 First release.
Foreword Copyright While all information contained herein have been carefully checked to assure its accuracy in technical details and printing, Vantron assumes no responsibility resulting from any error or features of this manual, or from improper uses of this manual or the software. Please contact our technical department for relevant operation solutions if there is any problem that cannot be solved according to this manual.
Limitation of Liability/Non-warranty For direct or indirect damage to this device or other devices of Vantron caused by failure of conforming to this manual or the safety instructions on device label, Vantron assumes neither warranty nor legal liability even if the device is still under warranty. The device should be installed, debugged and maintained by professionals. The outside antennas are not permitted to be installed or to be changed by nonprofessionals.
Ensure ventilation and smoothness according to relevant ventilation standards. Safety Instructions for Power Cables and Accessories Use Proper power source only. Start only with power source that satisfies voltage label and the voltage necessary according to this manual. Please contact technical support personnel of Vantron for any uncertainty about the requirements of necessary power source. Use tested power source.
Contents 1 2 3 4 5 INTRODUCTION ................................................................................................................................................ 1 1.1 PRODUCT DESCRIPTION................................................................................................................................................ 1 1.2 CONNECTOR DESCRIPTION ................................................................................................................................
6.1.1 Appearance ................................................................................................................................................... 12 6.1.2 Interfaces ....................................................................................................................................................... 12 6.1.3 Structure........................................................................................................................................................
1 1.1 Introduction Product Description Vantron offers both ARM and ATOM based Single Boards Computer (SBC) platforms including Cirrus Logic EP9315, RockChip RK3128, RK3368, RK3288, RK3399, Freescale iMX6, iMX8, TI OMAP35xx CortexA8 series, and Intel Skylake and ApolloLake processor boards. In additional to offering the standard SBCs, we also provide professional customization board design services.
3.3V 3.3 V signal level 5V 5 V signal level USB 5 V tolerant signal PCIe PCI Express signal, not 3.
2 2.1 Overview Introduction M10 PRO AND M10 LITE is a tablet computer designed for entertainment application. This product is based on RK3366 which has Quad-cores and one of them is Cortex-A55 with a maximum clock frequency of 1.8GHz, supporting 10.1" LCD and capacity touch screen. 2.2 Feature Specification Rockchip RK3566, Quad core, ARM CortexA55, 1.
Operating: 0℃~+45℃ Storage: -20℃~+45℃ Operating: RH 20%-80% Storage: RH 20%-80% FCC (Part 15 Class B) ESD (contact: ±4KV and air: ±8KV) Temperature Environment Condition Humidity Certification 2.3 Order Information Order Info -x -xx -xxx M10 Pro -x2: Light/proximity -2: NFC supported sensor supported -1: NFC not -x1: Light/proximity supported sensor not supported Example M10 Lite-221: 2GB DDR and Wi-Fi ac/a/b/g/n & BT5.
3 Hardware Instructions 3.1 Appearance Figure 3-1 Views 3.
Rear camera Light sensor Audio jack SD slot Power button SIM slot Touch screen Volume button Front Camera USB Type-A USB Type-C Speaker 3.3 Structure Download the board structure document from Vantron technology or Vantron net site: www.vantrontech.com.
4 Hardware Function Description This chapter mainly describes the main hardware functions of this product, including 4G, WIFI/BT, audio, display, camera,and,NFC. 4.1 EG95-NAX 4G Module EG95-NAX provides data connectivity on LTE-FDD networks. Its frequency bands include LTE-FDD (B2/B4/B5/B12/B13/B25/B26). It has two antennas: main antenna and Rx-diversity antenna. 4.2 WIFI/BT The wireless module inside the tablet complies with IEEE 802.11 a/b/g/n/ac standard and it can achieve up to a speed of 433.
4.3 Audio M10 PRO AND M10 LITE has a 3.5 mm Headphone jack, a 1.0W Speaker and a MIC. The headphone jack supports drive-by-wire control and mic function. If you want to use both of these features, your headphones must support them, too. Our headphone jack is compatible with three-section headphone and four-section headphone. 4.4 Display M10 PRO AND M10 LITE has a 10.1" screen. The screen is made up of a display screen and a touch screen, which are fitted together by full-fit technology.
4.7 NFC M10 PRO AND M10 LITE has a NFC feature, which is an optional feature. If the customer needs it, we can provide it.It Support 40mm away identify for tag1,42mm for tag 2 and 22mm for tag 4.
5 Hardware Operation Note This chapter provides a guide to set up and use some of the features of the tablet. For more details, see hardware description. 5.1 Power Preparation 5.1.1 Environment Before the equipment is powered on, please confirm whether the environmental conditions meet the requirements. Environmental conditions are as follows: ● Operation Temperature: 0°C ~ +45°C ● Operation Humidity: 10-85%RH (Non-Condensation) 5.1.
Figure 5-1 Internal antenna 4G RX-diversity Ant 4G Main Ant WIFI&BT Ant In order to ensure that the tablet functions can work properly, please do not cover the antenna area with metal shielding devices. Note: Frequency bands of 4G module include LTE-FDD (B2/B4/B5/B12/B13/B25/B26). WIFI and BT antenna frequency is 2.4G and 5G respectively.
6 6.1 6.1.1 Parts Description USB Power Adapter Appearance Figure 6-1 View 6.1.2 Interfaces Figure 6-2 Interfaces US 2 pins plug USB TYPE-A 6.1.
Figure 6-4 Structure (2) Unit: mm 6.1.4 Hardware Instructions Specifications Product Name AC/DC ADAPTER MODEL No. MX15U-0503000UU Interface Type USB Type-A ( Female ) Input Parameter 100-240V ~ 50-60 Hz 0.
7 Software Instructions M10 PRO AND M10 LITE has been pre-loaded firmware. For more information, please refer to software user manual for software operation.
8 Tips Waste Disposal It is recommended to disassemble the device before abandoning it in conformity with local regulations. Please ensure that the abandoned batteries are disposed according to local regulations on waste disposal. Do not throw batteries into fire (explosive) or put in common waste canister. Products or product packages with the sign of “explosive” should not be disposed like household waste but delivered to specialized electrical&electronic waste recycling/disposal center.
Notice Considering that reasonable efforts have been made to assure accuracy of this manual, Vantron assumes no responsibility of possible missing contents and information, errors in contents, citations, examples, and source programs. Vantron reserves the right to make necessary changes to this manual without prior notice. No part of this manual may be reprinted or publicly released in forms of photocopy, tape, broadcast, e-document, etc.
by independent scientific organizations through evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. The SAR limit of USA (FCC) is 1.6W/Kg averaged. Has also been tested against this SAR limit. SAR information on this and other pad can be viewed on-line at http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search.
d’exposition au rayonnement du CNR-102 de l’IC établies pour un environnement non contrôlé. Les lignes directrices sont fondées sur des normes qui ont été élaborées par des organisations scientifiques indépendantes au moyen d’une évaluation périodique et approfondie des études scientifiques. Les normes comprennent une marge de sécurité substantielle conçue pour assurer la sécurité de toutes les personnes, indépendamment de leur âge ou de leur état de santé. La limite SAR d’ISD est de 1.6 W/Kg en moyenne.
Appendix A: How to Contact Us If you have any problem or want to know more about our products, visit www.vantrontech.com or contact us. US Office: Vantron Technology, Inc. Address: 440 Boulder Court, Suite 300, Pleasanton, CA 94566, USA Tel: 925-621-8758 Email: sales@vantrontech.com China Office: Chengdu Vantron Technology, Ltd Address: 6th Floor, 1st Building, No.9, 3rd Wu Ke East Street, Wu Hou District, Chengdu 610045, China Tel: 86-28-8512-3930/3931, 8515-7572/6320 Email: sales@vantrontech.com.