VSUB235 User’s Manual 900 MHz RadioLink Daughter Board 2 Vantage Controls 1061 South 800 East Orem, UT 84097 (801) 229-2800 April 29, 2006
FCC Compliance Information FCC ID: PII-VSUB235 IC: 3505A-VSUB235 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Introduction The VSUB235 is an RF transceiver module. It interfaces with other equipment using standard serial asynchronous communications protocol at a rate between 9600 and 57600 baud. The transmitter has a peak output power of 123mW. It is designed to be incorporated into control devices developed by Vantage Controls. The module operates under FCC approval in the 902-928 MHz ISM frequency band.
Interface Pins: Pin # 1 2 3 4 5 Description Power RX (DATA_IN) Ground TX (DATA_OUT) /Reset PCB Footprint The PCB footprint is located in the PADS corporate library under the name “SUB_RFDB_4”
Specifications Model #: ....................................................................................... VSUB235 Frequency Range .................................................. 902-928 MHz ISM Band Power Supply................................................................................. 5-9 VDC Current required while transmitting ...................................................150mA Current required while receiving .........................................................70mA Antenna Gain .