User’s Manual 900 MHz Daughter Board VSUB075(REV A1) Vantage Controls 1061 South 800 East Orem, UT 84097 (801) 229-2800 JUNE 12, 2002
FCC Compliance Information FCC ID: PII-VSUB075-1 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Introduction The VSUB075 is an RF transceiver module. It interfaces with other equipment using standard serial asynchronous communications protocol at a rate between 9600 and 57600 baud. The transmitter has a peak output power of 140mW. It is designed to be incorporated into control devices developed by Vantage Controls. The module operates under FCC approval in the 902-928 MHz ISM frequency band.
Interface Pins: Pin # 1 2 3 4 5 Description Power RX Ground TX /Reset PCB Footprint The PCB footprint is located in the PADS user library under the name “RFDAUGHTERBOARD”
Specifications Model #: ................................................................................VSUB075 (REV-A1) Frequency Range .........................................................902-928 MHz ISM Band Power Supply.........................................................................................8-12 VDC Current required while transmitting .........................................................180mA Current required while receiving .......................................................