User's Manual

ManualsBrandsVantage Controls ManualsElectronics902-928 MHz transceiver module

ETII RF

OEM/Integrators Installation Manual

900 MHz RadioLink Control Board Module

The module is limited to OEM installation ONLY

Vantage Controls

2168 W Grove Parkway, Ste 300

Pleasant Grove, UT 84062

(801) 229-2800

June 22, 2017

Summary of content (6 pages)

PAGE 1
ETII RF OEM/Integrators Installation Manual 900 MHz RadioLink Control Board Module The module is limited to OEM installation ONLY Vantage Controls 2168 W Grove Parkway, Ste 300 Pleasant Grove, UT 84062 (801) 229-2800 June 22, 2017
PAGE 2
FCC Compliance Information FCC ID: PII-22713 IC: 3505A-22713 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 3
IC Compliance Information IC: 3505A-22713 This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. IC Notice (Avis D'Industrie Canada) PRUDENCE: Changements ou modifications pourraient annuler le droit de l'utilisateur à utiliser l'équipement non autorisées.
PAGE 4
Introduction The ETII RF is an RF Control Board Module that contains a microcontroller and a RF transceiver chip. It is designed to be incorporated into control devices developed by Vantage Controls. The module operates under FCC approval in the 902-928 MHz ISM frequency band. The module is limited to OEM installations only. The module is limited to installation in mobile or fixed applications.
PAGE 5
FCC RF Exposure requirement In order to comply with the FCC RF exposure requirements, the ETII RF may be used only with the antenna that has been tested and certified. The certified antenna is located on the module and has a permanent connection to the ET II RF Module: Manufacturer Model # Type Gain(dBi) Ethertronics M620720 Chip 2.6 Minimum Cable Length N/A A minimum separation distance of 20 cm must be maintained from the antenna to any nearby persons.
PAGE 6
Specifications Model #: ........................................................................................... ETII RF Frequency Range .................................................. 902-928 MHz ISM Band Power Supply ................................................................................. 5-9 VDC Current required while transmitting ................................................... 150mA Current required while receiving .........................................................