Owner's Manual

ManualsBrandsValeo Comfort and Driving Assistance ManualsElectronicsA08TAA, A08TAB

Valeo Sécurité Habitacle

Product Group Interior Electronics

Business Group Comfort & Driving Assistance

[1/5]

Owner Manual (draft)

Model: Transmitter (CD4 IKT)

Model No.: A08TAA, A08TAB

FCC ID: N5F-A08TAA

IC: 3248A-A08TAA

(preliminary draft, some change may appear in the final version)

Summary of content (5 pages)

PAGE 1
Valeo Sécurité Habitacle Product Group Interior Electronics Business Group Comfort & Driving Assistance Owner Manual (draft) Model: Transmitter (CD4 IKT) Model No.
PAGE 2
Remote Keyless Entry - Top view - UnLock button Lock button Trunk opening button Panic button Model A08TAB A08TAB (4 buttons) Model A08TAA A08TAA (3 buttons) - Botton view - Car Maker logo (brand) [2/5]
PAGE 3
1. OPERATION LOCK Press this button once to lock all doors. Some exterior lights will flash once (to be confirmed). Doors can not be locked if any door is not fully closed or the key is in the ignition switch. UNLOCK Press this button once to unlock the driver’s door. Push it twice to unlock the other doors. Some exterior lights will flash twice (to be confirmed) each time you press the button. This button does not work when the key is in the ignition switch.
PAGE 4
3. BATTERY REPLACEMENT The battery is not rechargeable. To replace the battery: ① Push the button on the transmitter to extend the key blade. ② Remove the battery cover by prying it with a finger. Note the polarity. ③ Remove the battery by pushing on the battery and sliding it toward the key blade. ④ Insert the new battery, positive side facing up. Push the battery down until it is held in place. Replace with a CR2032 or equivalent battery.
PAGE 5
REGULATORY INFORMATION For USA & Canada FCC ID: N5F-A08TAA IC: 3248A-A08TAA English: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standards. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.