Specifications

ManualsBrandsValcom Manualsaudio & home theatre5 -Watt High Efficiency IP Horn

1 947628

ISSUE 3

VIP-130L IP Paging Horn

INTRODUCTION

The VIP-130L IP Paging Horn is a self contained

paging system which enables voice paging up to

1200 feet from an Ethernet connection. The

VIP-130L consist of a high efficiency 5 Watt

Class-D Horn and a VIP-LLE Network Extender

allowing stand alone capability when used with a

SIP enabled telephone System or can be

accessed from a variety of Valcom managed

VoIP products.

SPECIFICATIONS

Access Methods

PBX, FXO Port w/VIP-811

POTS telephone set w/VIP-811

PBX, FXS Port w/VIP-821

Valcom M Cast Page Group

SIP – enable telephone system

Features

RJ-45 network connection

LED Status Indicator

Network activity LEDs

802.3af compliant

High Efficiency Class-D 5 Watt Amplifier

Dimensions/Weight

(Horn)

7.00” H x 10.00" W x 10.00" D

(18.75 cm H x 25.4 cm W x 26.4 cm D)

Weight: 5.8 lbs. (2.63 kg)

Network Extender

(VIP-LLE)

1.30” H x 6.10" W x 6.00" D

(3.51 cm H x 15.72 cm W x 13.51 cm D)

Weight: 0.85 lbs. (0.39 kg)

Nominal Specifications – HORN

Input Impedance: 600 Ohms

Input Level: -10dBm

Output Impedance: 600 Ohms

Output Level: -10dBm nominal

Nominal Specifications – VIP-LLE

Via 802.3af PoE Ethernet Switch:

Class 3 (12.95W)

Environment

Temperature: 0 to +40° C

Humidity: 0 to 85% non-precipitating

Packing List

Qty

Item

VIP-LLE Network Extender

5 Watt High Efficiency Horn

VSP Document

Mounting Brackets

Rubber Pads

Wood Screws

RJ-45 Termination Block

RJ-45 Patch Cable

Summary of content (4 pages)

PAGE 1
ISSUE 3 VIP-130L IP Paging Horn INTRODUCTION The VIP-130L IP Paging Horn is a self contained paging system which enables voice paging up to 1200 feet from an Ethernet connection. The VIP-130L consist of a high efficiency 5 Watt Class-D Horn and a VIP-LLE Network Extender allowing stand alone capability when used with a SIP enabled telephone System or can be accessed from a variety of Valcom managed VoIP products.
PAGE 2
INSTALLATION FCC Information This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
PAGE 3
Signal Connections (Fig. 1) Status Indicator Lights Connect CAT-5 cable from the rear panel color coded connector of the VIP-LLE Network Extender to the supplied RJ-45 termination block (900 feet maximum distance). Use the supplied CAT-5 patch cable to connect the RJ-45 connector of horn to RJ-45 termination block. The VIP-LLE Network Extender has 3 status indication lights: STATUS: Flashes during normal operation, and solid when unit in reset.
PAGE 4
TECHNICAL ASSISTANCE Assistance in troubleshooting is available from the factory. Call (540) 563-2000 and press 1 for Technical Support or via email at support@valcom.com. When requesting assistance, you should include all available information. It is strongly suggested that you go to the web site and follow the trouble resolution procedure at http://voip.valcom.com Valcom equipment is not field repairable. Valcom, Inc. maintains service facilities in Roanoke, VA.