INSTALLATION AND USER GUIDE AUTOVIEW IR SENSOR KIT Single Ceiling Mounted Active IR Sensor with AutoVIEW IR Control Interface and Power Supply P/N: 999-1701-100 North America 999-1701-101 International ©2012 Vaddio - All Rights Reserved ● AutoVIEW IR Sensor Kit ● Document Number 341-233-1 Rev.
AutoVIEW IR Sensor Kit Inside Front Cover - Blank AutoVIEW IR Sensor Kit Manual 341-233-1 Rev.
AutoVIEW IR Sensor Kit AutoVIEW™ IR Sensor Kit Single Ceiling Mounted Active IR Sensor with AutoVIEW IR Control Interface and Power Supply P/N: 999-1701-100 North America, 999-1701-101 Int’l The Vaddio™ AutoVIEW IR Sensor Kit is a ceiling mounted presenter camera control system that provides for automated presenter control over the Vaddio family of camera switching systems.
AutoVIEW IR Sensor Kit Unpacking: Carefully remove the device and all of the parts from the packaging. Unpack and identify the following parts: One (1) AutoVIEW Active IR Sensor (modified Optex with RJ-45 connector to support Cat-5e cabling) One (1) Dark Acrylic Lens Cover One (1) AutoVIEW Control Interface with 2-pin Phoenix type connector One (1) 18VDC, 2.
AutoVIEW IR Sensor Kit The AutoVIEW IR Control Interface: The AutoVIEW IR (AIR Box) Control interface supplies power the IR Senor and returns a closure pair (short to ground) to the TRIGGER OUT which can be connected into any Vaddio or other device with a trigger input. The plastic box for the control interface is approximately 3” (76.2mm) W x 2” (50.8mm) H x 1” (25.
AutoVIEW IR Sensor Kit Basic Installation The AutoVIEW IR Sensor is a modified Optex Sensor usually used in automatic door systems. 1) Affix the mounting template to the sensor mounting position 2) Drill or cut a 5-1/8” (130mm) round mounting hole for the sensor Recommended distance to the nearest wall is 12” (304.
AutoVIEW IR Sensor Kit Warranty Information: (See Vaddio Warranty, Service and Return Policies posted on vaddio.com for complete details): Hardware* Warranty: One year limited warranty on all parts. Vaddio warrants this product against defects in materials and workmanship for a period of one year from the day of purchase from Vaddio. If Vaddio receives notice of such defects during the warranty period, they will, at their option, repair or replace products that prove to be defective.
AutoVIEW IR Sensor Kit Toll Free: 800-572-2011 ▪ Phone: 763-971-4400 ▪ FAX: 763-971-4464 www.vaddio.com ©2014 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing are AutoVIEW Sensor without Kit Manual 341-233-1 Rev. ControlVIEW, C Page 8 of 8 subject toIR change notice. Vaddio, AutoPresenter, Quick-Connect, AutoVIEW, ProductionVIEW, Hot-Shot and PowerRite are registered trademarks of Vaddio.