User's Manual

1048889A DRAFT • November 2005
Copyright © 2005, GE Security Inc.
RCR-REX Request-to-Exit Dual Technology Motion Sensor
Installation Instructions
Introduction
This is the GE RCR-REX Request-to-Exit Dual Technology Motion
Sensor Installation Instructions
for models RCR-REX-W,
RCR-REX-B, and RCR-REX-G.
Installation
Determine if the sensor will be ceiling or wall mounted. Avoid
locating the sensor between double doorways where objects can
be inserted through a crack to gain unauthorized entry.
To install the sensor, do the following:
1. To open the front cover, insert a small screwdriver into the
bottom of the locking tab and pull upward (Figure 1).
Figure 1. Open the cover
2. Remove the screw holding the circuit board (PCB) cradle
axle to the back housing and carefully remove the circuit
board with cradle from the housing (Figure 2).
Figure 2. Remove the circuit board and cradle
3. Route wiring to the sensor mounting location. If you are
using the wall plate, pull the wires through the cable entry
hole (Figure 3).
Figure 3. Mounting and wiring access
4. Insert the mounting screws into the back (wall mount) or top
(ceiling mount) mounting screw holes to fasten the back
housing and wall plate, if used, to the wall or ceiling
(Figure 3).
5. Reinstall the PCB/cradle and secure in place with the PCB
axle screw (Figure 2).
6. Complete wiring connection (See Wiring on page 2).
7. Swing the front cover in place and walk test the sensor for
appropriate coverage and function (see Initial power up on
page 4.
CAUTION: When handling the sensor, do not touch the
lens window.
CAUTION: You must be free of static electricity before
handling sensor circuit boards. Touch a grounded,
bare metal surface before touching circuit boards or
wear a grounding strap.
Cradle Circuit board
PCB axle screw
Door
LL
Optional single gang box
LL
Door
Mounting screws
Optional wall plate