User's Manual

ManualsBrandsUTC Fire & Security Americas ManualsElectronics60-578

P/N 46-667 • REV J •23APR14 1

Learn Mode Water Resistant Pendant Panic

Button Installation Instructions

Introduction

This panic button can be used throughout the premises for

police, medical, or auxiliary alarm activation. When the sensor

button is pressed, the built-in transmitter sends a signal to the

panel (Figure 1 below).

Figure 1: 60-578 Pendant Panic Button

The water-resistant design helps prevent damage in case the

sensor accidently gets wet.

The sensor can be worn using the built-in belt clip or it can be

mounted on a wall in a location convenient for the customer,

using the optional wall-mount holder (kit number 80-116). Each

kit includes the following:

• 5 wall-mount holders;

• 5 pieces of double-sided tape;

• 10 plastic anchors; and

• 10 Phillips-head screws.

You will also need a small Phillips screwdriver (if installing the

optional wall-mount holder).

Installation guidelines

Use the following guidelines when installing this button:

• The transmitter in the button has an open-air range of up

to 1,000 ft. (305 m), but the installation environment may

influence this range.

• When mounting on a wall, determine the best location for

each panic button so it is easily accessible.

• The 3.5 VDC lithium battery will last at least 12 months.

Installation

You can mount the optional wall-mount holder, using anchors

and screws or double-sided tape.

To mount the holder with anchors and screws:

1. Place the holder on the wall at the desired location and

mark the mounting holes with a pencil (Figure 2 below).

Figure 2: Mounting with screws

Mounting hole

2. Secure the holder to the wall with the screws supplied.

Use the anchors supplied where studs are not present.

To mount the holder with double-sided tape:

1. Peel off the colored backing from the double-sided tape

and place it on back of the holder (Figure 3 below).

Figure 3: Mounting with double-sided tape

Affix

tape

here

2. Peel off the other backing and firmly press the holder

against the mounting surface.

Summary of content (2 pages)

PAGE 1
Learn Mode Water Resistant Pendant Panic Button Installation Instructions Introduction Installation This panic button can be used throughout the premises for police, medical, or auxiliary alarm activation. When the sensor button is pressed, the built-in transmitter sends a signal to the panel (Figure 1 below). You can mount the optional wall-mount holder, using anchors and screws or double-sided tape. To mount the holder with anchors and screws: 1.
PAGE 2
Programming This section describes the basic steps for adding the sensor to panel memory. For complete instructions, refer to the specific panel’s documentation. To program the sensor: 1. Set the panel in program mode. 2. When prompted by the panel, enter the appropriate group number (groups 00 through 07). Note: Be sure to assemble the sensor correctly to ensure water resistance. Be especially careful not to nick or damage the rubber gasket lining. 4.