User's Manual

ManualsBrandsUTC Fire & Security Americas ManualsElectronicsTRAC-Lid BT

Introduction

TheTRAC-Vault BT is an intelligent storage device

that holds multiple keys or access cards and records a

comprehensive audit trail of who accessed it and when.

The following hardware is recommended for this

installation:

• Four HECO MMS-SS 10 x 100 screws

For best results, consult with a local fastener or

hardware store.

You can order an installation kit from Supra that contains

all the necessary hardware for installing the TRAC-Vault

BT. An interior cover plate is also available.

TRAC-Vault BT installation

Install the TRAC-Vault BT in a location convenient for

your keyholders. To meet ADA requirements, the unit

must be installed 48 inches from the ground to the

center of the device.

To install the TRAC-Vault BT, you will need the

following equipment:

• Drill

• Drill bits

• Wrenches

• Pliers or vice grips

• Level or punch

• Pen or pencil

• Dremel tool or hacksaw

To install the TRAC-Vault BT on a rendered wall:

1. Hold the vault in the desired postion on the wall,

being careful to locate the four mounting holes away

from mortar lines and away from the edge of the wall

as well as possible.

2. Using a marker, trace the location of all 4 mounting

holes.

3. Using a drill with an 8 mm masonry drill bit, drill each

hole to a depth of 105 mm. After drilling each hole,

P/N10103266P1•August2012

TRAC-Vault BT • Surface Mount

Installation Instructions

Figure 2. TRAC-Vault, side view

ensure that each hole aligns with the 4 holes in the

back of the vault.

4. Clean out the debris from all 4 holes.

5. Insert one of the HECO mounting screws onto the

chain mounting bracket.

6. Place the TRAC-Vault up to the wall (drain hole

Figure 1. Mounting holes

Tighten bolts in the sequence

indicated by these numbers

Mounting holes

for 5/16” bolts

(4 places)

Hole for tamper

switch wires

Drain hole

Lock washer

Nut

TRAC-Vault

TRAC-Lid BT

Drain hole

Lid chain

attachment

Vault

chain bracket

Summary of content (3 pages)

PAGE 1
TRAC-Vault BT • Surface Mount Installation Instructions Introduction TheTRAC-Vault BT is an intelligent storage device that holds multiple keys or access cards and records a comprehensive audit trail of who accessed it and when. P/N 10103266P1 • August 2012 © 2012 UTC Fire & Security. All rights reserved. Figure 1.
PAGE 2
down) and insert each mounting screw all the way through the mounting holes in the vault, with the chain mounting bracket in the lower left hole. Figure 3. Optional Tamper Switch 7. Tighten all 4 screw heads in the order shown in Figure 1 until they are flush with the back of the vault, and behind the vault lip. 8. Using the appropriate driver, drive all 4 screws into the wall a little at a time until all 4 screws are driven completely in and the vault is tight against the wall.
PAGE 3
each of the all-thread rods. Last, put a 5/16” nut on each rod and hand tighten without letting the rod rotate. (See Figure 5.) 7. With one hand, grip the end of the all-thread rod with either a plier, or vice grip. Then, with the other hand, tighten the nut with a 1/2” wrench while making sure the Vault stays level. Repeat this procedure for all four rods, and tighten to approximately 50-75in-lb or until firmly snug. Cut off the excess all-thread rod using an appropriate tool.