User's Manual

ManualsBrandsUSI ManualsElectronics802.11b/g/n + BT Wireless LAN Module

WM-BN-BM-26_A!WiFi+BT!Module!User!Manual!

PWN: 802.11b/g/n + BT Wireless LAN Module

FVIN: 7.10.324.2

Applicable Model No.: WM-BN-BM-26_A, WM-BN-BM-26_A_FF, WM-BN-BM-26_A_FF2,

WM-BN-BM-26_A_FF3, WM-BN-BM-26_A_FF4, WM-BN-BM-26_A_FF5

Summary of content (21 pages)

PAGE 1
WM-BN-BM-26_A WiFi+BT Module User Manual PWN: 802.11b/g/n + BT Wireless LAN Module FVIN: 7.10.324.2 Applicable Model No.
PAGE 2
PAGE 3
WiFi User Guide User SIDO interface in PC/NB to control WM-BN-BM-26_A
PAGE 4
PAGE 5
PAGE 6
PAGE 7
PAGE 8
PAGE 9
PAGE 10
PAGE 11
Bluetooth User Guide Install Bluetool on PC firstly. User UART in PC to control Bluetooth.
PAGE 12
PAGE 13
PAGE 14
PAGE 15
PAGE 16
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 17
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed with 20 cm is maintained between the antenna and users in mobile or fixed applications. 2) The Antenna for Module (COF-WMBNBM26A ) is Non-detachable and the maximum antenna gain allowed for use with this device is 3.68 dBi. 3) The transmitter module may not be co-located with any other transmitter or antenna.
PAGE 18
Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
PAGE 19
This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
PAGE 20
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate Canada authorization.
PAGE 21
intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué dans ce manuel.