MS-01 PRO SOM Module ` 1. WiFi and Bluetooth MS-01 Pro Integrated Qualcomm WCN3990 to support WLAN 2x2 802.11a/b/g/n/ac with DBS and 160 MHz, Bluetooth 5.0. n n n n 2 × 2 802.11ac with MU-MIMO DBS support 160 MHz bandwidth support Bluetooth 5.0 1.1 WLAN RF Characteristics 1.1.1 2.
` MS-01 PRO SOM Module 1.1.2 2.4 GHz WLAN Receiver Characteristic Parameter 1 Mbps DSSS (b) Rx Sensitivity 11 Mbps DSSS (b) Rx Sensitivity 6 Mbps OFDM (g) Rx Sensitivity 54 Mbps OFDM (g) Rx Sensitivity MCS0 OFDM (n) Rx Sensitivity MCS7 OFDM (n) Rx Sensitivity MCS0 OFDM (n) Rx Sensitivity MCS7 OFDM (n) Rx Sensitivity 802.
MS-01 PRO SOM Module ` 1.1.4 5 GHz WLAN Receiver Characteristics 1.
MS-01 PRO SOM Module ` 3. WWAN MS-01 Pro Integrated Qualcomm SDR660 Transceiver, Downlink Carrier Aggregation (2CA) DL: 2CA, 256QAM, 400Mbps UL: 64QAM, 75Mbps 3.1 Band Lists MS-01 use 1 SKU to support worldwide bands as below: n GSM: 850, 900, 1800, 1900 n WCDMA : B1,B2,B4,B5,B6,B8,B19 n LTE-FDD : B1,B2,B3,B4,B5,B7,B8,B12,B13,B17,B18,B19,B20,B25,B26,B28 n LTE-TDD : B38,B40,B41 3.
` MS-01 PRO SOM Module 3.3 3 LTE Output Power Condition Measured at RF Port, Nominal Conditions, Meets requirements per 3GPP TS 51.
` MS-01 PRO SOM Module 3.4 Primary Receive Performance 3.4.1 GSM Receive Sensitivity Condition Measured at RF Port, Nominal Conditions, Meets requirements per 3GPP TS 34.121 -1 Band GSM 850 EGSM 900 DCS 1800 PCS 1900 Typ -109 -109 -108 -108 3GPP ≤-104 ≤-104 ≤-104 ≤-104 Units dBm dBm dBm dBm Band B1 B2 B4 B5 B8 Typ -108 -108 -108 -109 -109 3GPP ≤-106.7 ≤-104.7 ≤-106.7 ≤-104.7 ≤-103.
` MS-01 PRO SOM Module 3.5 Diversity Receive Performance 3.5.1 WCDMA Receiving Sensitivity Condition Measured at RF Port, Nominal Conditions, Meets requirements per 3GPP TS 34.121 -1 3.5.2 LTE Receiving Sensitivity Condition Measured at RF Port, Nominal Conditions, Meets requirements per 3GPP TS 51.010-1 DL_Mod=QPSK, DL_RB=50, CH_BW=10MHz, UL_RB=25, TX_Pwr=23, TotalMPR=1 Band B1 B2 B4 B5 B8 Typ -110 -110 -110 -110 -110 3GPP ≤-106.7 ≤-104.7 ≤-106.7 ≤-104.7 ≤-103.
` MS-01 PRO SOM Module OEM/Integrators Installation Manual Important Notice to OEM integrators 1. This module is limited to OEM installation ONLY. 2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b). 3. The separate approval is required for all other operating configurations, including portable configurations with respect to Part 2.1093 and different antenna configurations 4. For FCC Part 15.
MS-01 PRO SOM Module ` Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
` MS-01 PRO SOM Module This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
` MS-01 PRO SOM Module This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed with 20 cm is maintained between the antenna and users in mobile or fixed applications. 2) The Antenna for Module (MS-01 PRO/MS-01 PRO-V) is Non-detachable and the maximum antenna gain allowed for use with this device is WWAN: 2dBi@698~791MHz,2dBi@824~960MHz,3dBi@1710~1880MHz, 1.5dBi@1910~2170MHz,1.4dBi@2300~2400MHz,1.5dBi@2500~2700MHz ; WLAN/BT: 1.44dBi@2.4GHz,2.
` MS-01 PRO SOM Module Antenna Information WIFI antenna Antenna Type: Dipole Antenna gain: 1.44dBi@2.4GHz and 2.16dBi@5GHz WWAN antenna Antenna Type: Dipole Antenna gain: 2dBi@698~791MHz,2dBi@824~960MHz,3dBi@1710~1880MHz, 1.5dBi@1910~2170MHz,1.4dBi@2300~2400MHz,1.
` MS-01 PRO SOM Module Antenna Trace Design WWAN MAIN_ANT Top layer WWAN AUX_ANT Top layer All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI.
` MS-01 PRO SOM Module WLAN chain0/BT Top layer WLAN chain1 Top layer The Land Pattern and Dimensions should be compliance with USI's Standard PCB Design. The characteristics of products may vary depending on the pattern drawing method, grounding method, land dimensions, land forming method of the NC terminals and the PCB material and thickness. Therefore, be sure to verify the characteristics in the actual set. When using non-standard lands, contact Universal Global Scientific Industrial Co., Ltd.
` MS-01 PRO SOM Module WWAN WLAN All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI.
` MS-01 PRO SOM Module USI uses various test mode programs for test set up which operate separate from production firmware. Host integrators should contact USI for assistance with test modes needed for module/host compliance test requirements. The MS-01 PRO, MS-01 PRO-V modular transmitter is only FCC authorized for the specific rule parts (i.e.
` MS-01 PRO SOM Module Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
` MS-01 PRO SOM Module IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or colocation with another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate Canada authorization.
` MS-01 PRO SOM Module RSS-247 Section 6.4 (5) (6) (for local area network devices, 5GHz) The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.
MS-01 PRO SOM Module ` CE RF exposure RF Exposure Information (MPE) This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. To comply with the RF exposure requirements, this module must be installed in a host platform that is intended to be operated in a minimum of 20 cm separation distance to the user. Hereby, USI declares that the radio equipment type LTE SOM Module is in compliance with Directive 2014/53/EU.
