Operation Guide

SR5600,SR5660,SR5680,SR70
Bluetooth Scanner Simple
Operation Guide
3.01.200.XXXXXX
Device Appearance and Commonly Used Buttons
Unpacking Instructions
Ring installation instructions
Direct charger installation instructions
Battery installation instructions
Device x 1 Battery x1
Direct charger x 1
Charger x1 Data cable x 1
Simple Operation Guide&Warranty Instructions&
Certificate of Conformity x 1
Packing List
Product Instructions
Align one end of the SR5600 lock catch and push the other end down
until it clicks into place. The ring can be installed as required. The
following figure 1 is for the right finger, and figure 2 is for the left finger.
Press the sliding buckle to remove the ring.
Insert the bottom of the SR5600 into the direct charger until it clips into
place. Connect the Type-C interface at the end of the direct charger
with the data cable and charger. Normal charging starts when the
indicator light indicates that the red light is always on.
Align the battery with the top of the SR5600 and insert it into the battery
compartment. Slide the battery all the way into the SR5600 locking slot
to ensure that the battery matches with SR5600.
Battery buckle
Indicator light
Battery
Scanning head
Ring code scanning button
Comfort
cushion
Cord buckle
Tape buckle
Direct charger
Finger tape
POGO PIN
I. Press and hold the power button and then release it. After booting,
SR5600 Bluetooth scanner (hereinafter referred to as SR5600)
automatically enters the Bluetooth Standby Pairing mode, and the
blue light keeps flashing;
II. Connect the SR5600 with the main device Bluetooth, there are
three connection methods as follows:
1. Search for the corresponding Bluetooth name SR5600-XXXX
(representing the last four digits of the Bluetooth Mac address) from
the Bluetooth list of the main device.
2. Connect via SR5600 NFC touch (press the NFC switch of the main
device, contact the main device with the SR5600 NFC, and follow the
steps prompted by the main device to successfully set up);
3. Connect by scanning the setting code (as described in Product
Instructions IV).
III. After successful connection, the blue light is always on,the buzzer
buzz twice, and the device starts working;
IV. To change the code system and other settings, download the
setting code APK or WeChat setting code applet from the official
account of "UROVO". After installation, set according to actual
requirements and the QR code will be generated. Scan the QR code
with SR5600, and the buzzer buzz twice, which indicates successful
setting.
Instructions for Status Light
Host code
scanning button
NFC
Sliding buckle
Power button
Figure1 Figure2
Battery lock catch
POGO PIN
Type-C
Type-C
Ring buckle
（Direct charger）
Status light Description
Red indicator light is always on Scanning code or charging
Red indicator light flashes once Setup failure
Green indicator light flashes once Scan code successfully
Green indicator light is always on
Blue indicator light is always on
Battery fully charged
the Bluetooth is connected successfully
Blue indicator light keeps flashing Bluetooth enters pairing mode