The Forge™ is the premiere Smokeless fire pit from Urban Fire™… and it is BIG. With an inside diameter of almost 30 inches, The Forge can handle more fire wood than any other smokeless fire pit on the market. The Forge is fully collapsible, making it easier to pack up for easy storage, or on the go. We used science to create a better atmosphere for you and your family around the fire. The Forge pulls air in from two sources: protected air holes in the base, and through hollow legs.
(t) Top Ring (f) “the forge” Leg (l) Logo Legs (x3) (w) Side walls (4) Hardware Contents (a) air channels Covers (4) (b) base plate • (4pcs) 1/4-20 x 0.5 Bolts (Q) • (1pc) Snap-In Cap (S) • (1pc) 5/32 Hex Wrench (H) hardware pack Questions? Issues with Damaged or Missing Parts? In order to best assist you, please contact YardCraft, the trusted distributor of Urban Fire products, NOT a third party retailer, with any questions regarding our products, damages, missing parts, or replacement parts.
Figure 1 Figure 2 Step 1: Locate and place 2 Logo Legs (L), on their sides, under the Base Plate (B), as shown in Fig. 1 Note: Keep the slots for the Air Channel Covers (A) open. Step 2: Locate and place 4 Air Channel Covers (A) in the rectangle slots on the Base Plate (B), as shown in Fig. 2 Note: The closed end of the Air Channel Covers (A) will be facing the center of the fire pit.
Figure 5 Figure 6 Step 5: Repeat Step #4 for the remaining two Logo Legs (L), as shown in Fig. 5 Note: When all of the legs are installed, the Base Plate (B) and the Air Channel Covers (A) will drop into place and lock in. Step 6: Locate one Side Wall (W) and align it with the rectangle slots on both legs, as shown in Fig. 6 Figure 7 Figure 8 Step 7: Insert the tabs on the Side Wall (W) into one of the legs, as shown in Fig. 7 Note: Be sure to keep the Side Wall raised until the next step.
Figure 9 Figure 10 Step 9: Repeat Steps # 6-8 for the remaining Side Walls (W), as shown in Fig. 9 Step 10: Locate the Top Ring (T) and lower it over the legs, as shown in Fig. 10 Note: Be sure to align the Urban Fire Logo on the Top Ring (T) with “The Forge” Leg (F). Figure 11 Step 11: Use the provided bolts (Q) to fasten the Top Ring (T) to each Leg (L & F) using the provided Hex Wrench (H), as shown in Fig. 11 Note: You may need to push/pull the legs while fastening for proper alignment.
congratulations! you have succesfully assembled the forge Fire pit! 6