User's Guide

0822-V1
2 3
4 5 6
Wireless Power Bank
Model: UAG-WF-BP5K
USER GUIDE
Enterprise
SPECIFICATIONS
Battery capacity
Battery charging input,
output
Wireless Status Indicator
Battery Indicator
Operating Environment
Storage Environment
3,000mAh (11.1Wh) Lithium Polymer
5,000mAh (19Wh) Lithium Polymer
10-Watt, 5V/2A max
Battery wireless charging 10
-Watt (Wireless)
1x Blue LED
4x White LED
0C to +40C (32°F to 104°F)
5% to 90% Relative Humidity
-15C to +50C (-59°F to +122°F)
5% to 90% Relative Humidity
BATTERY PACK INSTALLATION
1. To install the battery pack, insert the battery
pack at an angle starting at the bottom.
2. Let battery pack rest on the bottom of the
case and gently press the top down into the
case until it snaps in place.
3. To remove the battery pack. Push the battery
release button up and pull the battery pack
away from the case.
BATTERY PACK CHARGING
Charge the battery pack using a USB-C cable (not
included). You may also charge the battery using
the optional Workflow Charging Dock.
BATTERY PACK OPERATION
1. Press the battery button once to power on the
battery pack and enable device charging.
Press once to check battery charge status
2. Press the battery button twice to power off
the battery pack.
LED INDICATORS
Blue LED – Wireless charging indicator. Solid if
charging
White LED – (4) Battery charge status indicators
10%-25% charge
26%-50% charge
51%-75% charge
75%-100% charge
1 YEAR LIMITED WARRANTY
For warranty terms and conditions visit
urbanarmorgear.com/warranty
Urban Armor Gear, LLC
1601 Alton Parkway, Suite C, Irvine, CA 92606
Made in China
FCC STATEMENT
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help
L’émetteur/récepteur exempt de licence
contenu dans le présent appareil esconforme
aux CNR d’Innovation, Sciences et
Développement économique Canada
applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) L' appareil ne doit pas produire de
brouillage;
(2) L' appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d' en compromettre le
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2)This device must accept any interference,
including interference that may cause undesired
ICES-003 Class B Notice - Avis NMB-003,
Classe B
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference
received, including interference that may cause
undesired operation.
The equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. During the operation of device a
distance of 0 cm surrounding the device and O cm
above the top surface of the device must be
respected.
conforme à la norme NMB-003 du Canada.
operation of the device.
fonctionnement.
WARNING: This Product can expose you to
chemicals including Bisphenol A, which is
known to the State of California to cause birth
defects or other reproductive harm.
wwwP65Warnings.ca.gov
PATENTS PENDING ©2022 URBAN ARMOR
GEAR. All rights reserved. URBAN ARMOR
GEAR® and UAG® logo are registered
trademarks of URBAN ARMOR GEAR. LLC.,
Laguna Niguel, CA. All other trademarks and
registered trademarks are the property of
their respective owners.
PACKAGING
114013BW4040
114023BW4130
114015BW4040
114025BW4130
DATE
0822
VERSION
1
NOTES
Size: 165 x 85mm