Installation Manual Apply for all freestanding bath Please keep this page for your online registration. No. FIBABRB01V1.
CAUTION 2 • Risk of personal injury. Bath tubs can be extremely heavy. Obtain sufficient help to carefully lift or move the bath tub. • Risk of property damage. Make sure that a watertight seal exists on all bath drain connections.
BEFORE INSTALLATION Before installation check that all fittings have been suppied. Assembled bath on a mat to protect against damage to bath surface. This product requires a two person lift-use proper lifting techniques. This installation guide recommends a bath waste be fitted to the bath prior to installation - if any doubt about Installation and waste connection please consult a qualified tradesmen Follow each step in turn. IMPORTANT:All installations must comply with council and local authority by-laws.
INSTALLATION PROCEDURE 4 1 Place the bath upside down on a dust sheet or soft cloth so not to scratch the surface. Level the feet on the base of the bath and lock them into place. 2 Turn the bath over and temporarily place in what will be final position in the bathroom.Check along the top of the bath using a spirit level and adjust the feel if necessary and lock into place.
INSTALLATION PROCEDURE 3 Turn the bath upside down and fit either a P trap or S trap (not supplied) to the bath waste dependant on the household waste pipe configuration. 4 Turn the bath the right way up and rest on two blocks(ideally4”x4”)in position to gain access underneath to attach the household pipework.
INSTALLATION PROCEDURE 5 6 Once the waste option has been chosen and attached to the household pipework water should be poured through the waste to check for leaks.Once this has been done apply silicon to the underside of the bath to complete the look.
6 Please allow 24 hours for the silicon to dry off before use.The installation guide includes options for waste connection: The final decision about installation and waste connection should be taken by a qualified person. AFTER INSTALLATION Run water into the bath and check connections for leaks. CARE & CLEANING Use a soft cloth or sponge for cleaning .Don not use any scouring pads like pot cleaners etc. as this will dull the surface Use mild soap and water for everyday use.
