PRODUCT BOOKLET Uface 8T-Temp ( OS-M385C2-C-R23WFC-TEMP03 )
1/2 Platform/Software Operating Instruction Dear customer: Thank you for using our product. For better use, please carefully read this instruction. If you have any issues not mentioned here, please contact the provider. All parts of this booklet are reserved by our company, including words, pictures and graphics. Without written permission, no unit or individual Please mark the need for software version when place the order.
Illumination intensity The recognized face, of which, the illumination intensity ( “intensity” in short) shall not be lower than 30 Lux when the device put in a totally dark environment, the face illumination intensity, 0.5m distance to the device, is about 100 Lux. The nearer to the device, the higher the intensity is. If there is overexposure on the face, the face characteristics will be unable to be extracted and may lead to hard recognition.
5/6 Steps 1 According to the site requirements, drill a 32mm-diameter hole in the gate (commonly in the middle or the front), as shown on the picture, is the suggested hole position. Single-channel gate 3 Insert the column and cables into the hole on the gate, from top to bottom. Dual-channel gate 50CM Tighten the nut Attention: Hole position should be decided by actual scenes and applied gate type, 50cm is the reference value only.
7/8 Wiring connection Wiring for automatic door Installation notes 1. When arrange the wires, if the 12V power supply cable of the host does not adopt the “Special power strip” and is in long distance, resulting in large resistance, then abnormal phenomena may occur easily such Auto-door controller + assembly units Sensor (inside) metering is shown as follow.
Features • Characteristics Infrared and RGB dual-camera, live face detection; completely solve image frauds in all kinds of carriers; recognition accuracy is 99.99% (passing rate is 99.77% under 1% false accept rate; passing rate is 99.27%under 0.1% false accept rate).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.