PRODUCT BOOKLET Uface 8-H Temp ( OS-M385C2-V-R23WFC-TEMP05 )
Dear customer, Thank you for using our product. For better use, please carefully read this instruction. If you have any 1/2 Platform/Software Operating Instruction / issues not mentioned here, please contact the provider. All parts of this booklet are reserved by our company, including words, pictures and graphics. Without written permission, no unit or individual Please mark the need for software version when place the order.
Illumination intensity 3/4 Position The recognized face, of which, the illumination intensity “intensity” in short) shall not be lower than 30 Lux when the device put in a totally dark environment, the face illumination intensity, 0.5m distance to the device, is about 100 Lux. The nearer to the device, the higher the intensity is. If there is overexposure on the face, the face characteristics will be unable to be extracted and may lead to hard recognition.
5/6 Steps 1 Paste hole papers, and keep the horizontal line parallel with the ground and the red line 1.4m distance to the ground. Drill 4 screw holes on the wall according to the reminder of hole paper, drill 1 outlet hole according to wiring need. If the wall is hard foundation, use expansion pipe in the parts to knock into the hole. 3 Move the support (device) to align the 4 holes on it with holes on the wall, and use the wall-mouting sticker wall-mouting sticker 1.4m calibration 1.
7/8 Wiring connection Wiring for magnetic door Magnetic lock Access control relay interface Auto-door controller + assembly units Door exit (inside) Host Installation notes Wiring for automatic door 1. When arrange the wires, if the 12V power supply cable of the host does not adopt the “Special power strip” and is in long distance, resulting in large resistance, then abnormal phenomena may occur easily such as Sensor (inside) Access control relay interface shown as follow.
Features • Characteristics Infrared and RGB dual-camera, live face detection; completely solve image frauds in all kinds of carriers; recognition accuracy is 99.99% (passing rate is 99.77% under 1% false accept rate; passing rate is 99.27%under 0.1% false accept rate).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
