PRODUCT BOOKLET
Product number OS-M385C2-C-R23WF OS-M385C2-C-R23WF (Pictures for reference only, subject to our products)
Thank you for using our product. For better use, please carefully read this instruction. If you have any issues not mentioned here, please contact the provider. All parts of this booklet are reserved by our company, including words, pictures and graphics. Without written permission, no unit or individual shall extract, copy, translate or edit the content in this instruction.
The recognized face, of which, the illumination intensity ( “intensity” in short) shall not be lower than 30 Lux. The device has filling light itself, so when the device put in a totally dark environment, the face illumination intensity, 0.5m distance to the device, is about 100 Lux. The nearer to the device, the higher the intensity is. If there is overexposure on the face, the face characteristics will be unable to be extracted and may lead to hard recognition.
/6 Steps 1 According to the site requirements, drill a 32mm-diameter hole in the gate (commonly in the middle or the front), as shown on the picture, is the suggested hole position. Single-channel gate 3 Insert the column and cables into the hole on the gate, from top to bottom. 4 At the gate bottom, thread the cable interfaces out the nut one by one, align the nut with thread and then tighten.
7/8 Wiring connection Wiring for automatic door Installation notes 1. When arrange the wires, if the 12V power supply cable of the host does not adopt the “Special power strip” and is in long distance, resulting in large resistance, then abnormal phenomena may occur easily such as insufficient voltage (≤11V), repeat restart, system crash and so on. Wiring connection of voltage ~220V Auto-door controller + assembly units Sensor (inside) metering is shown as follow.
Features • Characteristics Night infrared, RGB dual-filling light; completely resolve image frauds in all kinds of carriers with dynamic dual-camera and live detection; the 1:N recognition accuracy is 99.99% under 0.1% false accept rate. 9 / 10 FAQ • Try to restart and reset When the device stops in some interface for a long time, users can plug out the power switch, power-on reset and then restart.
FCC Radiation Exposure Statement: The transmitter must not be colocated or operated in conjunction with any other antenna or transmitter. This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. Information to Users According to the FCC Part 15.19, 15.21, and 15.