User's Manual

ManualsBrandsUniversal Surveillance Systems ManualsElectronicsPower 4 System

USS POWER OF 4™

Contents

• About this Guide

• Limitation of Warranty

• System Overview

• Materials Required

• Installation Requirements

• Set up Procedure

• Specifications

• Declarations

About this Guide

This User’s Guide provides functional overview of the

Power of 4™ along with the Installation Requirements and

Setup Procedure for the User.

Limitation of Warranty

Any deviations from the materials or procedures

specified herein shall void the warranty of Universal

Surveillance System with the owner/buyer. In no event shall

Universal Surveillance Systems be liable for loss or damage

caused by the use of materials or procedures that do not

meet the specifications of Universal Surveillance Systems.

Innovative Securit

Solutions

User’s Guide

USSProducts\Powerof4™\User’sManual Page1

Summary of content (6 pages)

PAGE 1
User’s Guide Innovative Security Solutions USS POWER OF 4™ Contents • • • • • • • • About this Guide Limitation of Warranty System Overview Materials Required Installation Requirements Set up Procedure Specifications Declarations About this Guide This User’s Guide provides functional overview of the Power of 4™ along with the Installation Requirements and Setup Procedure for the User.
PAGE 2
System Overview The Power of 4™ is an advanced EAS System with early detection tools. It provides four levels of security, which include: • • • • EAS Technology: The System has advanced Acousto-Magnetic Technology detection designed to detect 58 KHz hard tags and labels. Audible and visual alarms are provided for the detection. Booster Bag/Foil Lined Bag Detection: The System includes an early detection system that triggers an alarm when a Booster Bag/Foil Lined Bag is detected.
PAGE 3
Figure 1. USS Power of 4™ • Check the Store’s electrical supply: There should be a minimum of 4 outlets for the AM Control Box while the Electrical Line should be a dedicated 110V AC @ 60Hz. Neutral to ground voltage check should be a maximum of 0.5 VAC. WARNING! Do not install this product in hazardous areas where highly combustible or explosive products are stored or used. • WARNING—RISK ELECTRIC SHOCK! OF The AC power line could be carrying 110VAC.
PAGE 4
• Ensure good detection of all subsystems (EAS System, Booster Bag/Foil Lined Bag System, Magnet and Jammer Detector) before mounting pedestals to the ground. Spacing between pedestals should be from 5 to 6 ft and keeping appropriate distance between pedestals and doors. Power cables, computers, mirrors, and other big metal objects may affect the system operation so it is advisable to keep the pedestals away from these materials as much as possible.
PAGE 5
• If soft labels are used, RX ‘Sweep’ is recommended to be set to ON. Set RX ‘Sweep’ OFF if only hard tags are used. • Set the sensitivity of receivers (window “RX”). Gain is correct, if window "input level" shown on the computer screen is in green or green/yellow. Gain is acceptable, if "input level" is in yellow. If "input level" is in red, it is recommended to decrease the gain for the RX channel. Factory setting is 9 for optimal receiver sensitivity.
PAGE 6
Specifications • • • • • • • • Primary Input: 100-120 VAC @60Hz Input Power: 150W Operating Frequency: 58KHz (±200Hz) Transmitter: 2 multiplexed output channels Receiver: 4 multiplexed input channels Operating Temperature: 32° to 122°F (0° to 50°C) 2 Pedestals: 6-12 ft coverage (Pedestal seperation at 5-6 ft) Dimensions: a. Pedestal: 61”H x 19.5” W x 4” D b.