System Product Contract Mfg Business Division Draft User Manual for CB-G-IN-01, 03 Card Bus SOURCE ORGANIZATION: Prepared by: Amos USI COM/PDV/TPM Date: Jun, 13, 2003 Checked by: Approved by: Date: Concurrence: Date:
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 2 Change Sheet Description of change Rev. Date 1.0 2003/6/13 Page All Approval & Date Initial The content of this document is to be treated as strictly confidential and is not to be disclosed, reproduced or used, except as authorized i n writing by Universal Scientific Industrial Co. ,Ltd.
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 3 Overview This document is for a user who wants to install CB-G-IN-01, 03 CARD Bus in Notebook/PC desk , the user can read the document to configure his wireless PC Card. Software Requirement OS: Windows95,98,2K,NT,XP Software Package: USI_driver_11g_V1-0-8.zip Hardware Requirement CB-G-IN-01, 03 CARD Bus.
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 4 IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 5 harmful interference to radio or television reception, which can be determined by turning the equipment off and on , the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 6 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 7 This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
Universal Scientific Industrial Corp.. Doc No. Date. Document released by COM/PDV/TPM 2003/06/13 Draft User manual for CB-G-IN-01, 03 CARD Bus Description Rev Page 1.0 8 Technical Support Technical Contact : Universal Scientific Industrial Co., Ltd. ( Headquarters ) Address : 135, Lane 351, Taiping Rd., Sec. 1, Tsao Tuen, Nan Tou, Taiwan USI Taipei Office : 10F, 420, Keelung Road, Sec. 1, Taipei, Taiwan Contact Person : Ray Huang Telephone : +886-2-2345-5006, Ext.