User's Manual

ManualsBrandsUnited Integrated Services ManualsElectronicsWireless Power Switch

Confidential

WPW-220 Wireless Power

Switch (US)

Installation instructions

Table of Contents

一、 Product Overview .......................................................................................... 1

二、 Feature............................................................................................................ 1

三、 Installation Operation..................................................................................... 2

四、 Precautions ..................................................................................................... 2

五、 Troubleshooting ............................................................................................. 3

Summary of content (6 pages)

PAGE 1
WPW-220 Wireless Power Switch (US) Installation instructions 一、二、三、四、五、 Table of Contents Product Overview .......................................................................................... 1 Feature............................................................................................................ 1 Installation Operation..................................................................................... 2 Precautions .................................................................
PAGE 2
一、Product Overview 1. Product Name：Wireless Power Switch (US) 2. Model：WPW-220 3. Power supply：100~120VAC 4. Dimensions (mm) and Accessories：82 x 45x 36mm The controller base, manual 1. Setting LED status 2. Button (with warning lights) 3. (SET) set key 4. 3-point power outlet 5. 3-point power plug 二、Feature 1.
PAGE 3
5. Both wireless signal router functions, transmission system may extend the terminal host and detector distance. 三、Installation Operation 1. First WPW-220 connected to the power outlet, then will enter the boot mode, the blue light on the front of the boot will be completed after about 90 seconds of constant light. If you want to skip this program, press the SET button. 2.
PAGE 4
2. Power measurement ranges： (1) Measuring voltage range：100~130VAC (2) Measuring Current Range：0.3~10A (3) Measuring power range：30~1300W (4) Measuring the cumulative time in months, up to three months (as far back in 1 year) 3. As the wireless signal router can connect up to 16 wireless detectors. 1 set of system can accommodate up to 16 wireless signal router. 4. Wireless signals in series to host up to three relay. 五、Troubleshooting 1.
PAGE 5
Standby: LED Indicator Operation Interface ~1.32W Blue 1PC/Red 1PC LED Status: Relay (ON/OFF) Push button switch for setting on the side Push button switch for Relay on/off in front Operating Voltage 100~120VAC 50/60 Hz Resistive Load 10A/120VAC, 1200W max. Inductive Load (Single Face) 0.5HP/120VAC Over Current Protection 11A Measure Voltage Range 100~130VAC Measure Current Range 0.3A~10A± 10％ Measure Power Range 30~1300W± 10％ Software Protocol Version ZHA1.
PAGE 6
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted.