User's Manual

ManualsBrandsUnited Integrated Services ManualsElectronicsWIRELESS CONTACT SENSOR

Wireless Contact Sensor User's Manual

Product Name: Wireless Contact Sensor

Model No: WCS-110

Input Power: 3V DC

Features Description:

1. Wireless transmission to the reed switch (opens / closes) the signal to the repeater, we can

see that the doors and windows open and close the current state, to prevent thieves

invasive.

2. Use CR2032 type Li-ion batteries, battery power is insufficient to inform the host will

automatically operate a very low power; the battery can be used for more than two years.

3. Easy link, when install at the first time to press the set button on the side of product

binding with repeater.

Outline Dimensions:

Feature Locator:

Installation Hints:

1. Foundation stop plate

2. State of LED window

3. reed switch location

4. battery holder

5. (SET) Setting button

Summary of content (5 pages)

PAGE 1
Wireless Contact Sensor User's Manual Product Name: Model No: Wireless Contact Sensor WCS-110 Input Power: 3V DC Features Description: 1. Wireless transmission to the reed switch (opens / closes) the signal to the repeater, we can see that the doors and windows open and close the current state, to prevent thieves invasive. 2. Use CR2032 type Li-ion batteries, battery power is insufficient to inform the host will automatically operate a very low power; the battery can be used for more than two years. 3.
PAGE 2
1. Need to WCS-110 (Wireless Contact Sensor) Foundation stop plate and the magnet block to be installed on the doors or windows to detect in order to start using. 2. WCS-110 (Wireless Contact Sensor) Battery installation instructions are as follows maps, Add spin to open the battery holder, and then can be closed. (Attention: CR2032 Battery Positive side up) 3. WCS-110 (Wireless Contact Sensor) mounted to the Foundation stop plate described below map, linked to the drop of a good position to. 4.
PAGE 3
7. WCS-110 (Wireless Contact Sensor) Foundation stop plate can as shown below, doors or window frames placed in a static position, the magnet body in the door or window frame fixed movable parts. 8. Under the Foundation stop plate can map the location of locking screw holes in order to pay Gum adhesive or screw fixed way, Easy DIY installation of WCS-110(Wireless Contact Sensor) Ontology and Ontology magnet fixed on the door or window frame.
PAGE 4
Troubleshooting: 1. Problem : When link with WR-110 (Wireless repeater), there is no display of LED indicator light for WCS-110 (Wireless Contact Sensor) to flash two or three times. Solution : a. Need to make sure the battery is good there is electricity, the installation of the battery positive and negative direction is correct. b. May be not press set button, need to link with repeater again. c. If the above handles are invalid, please contact with agency. 2.
PAGE 5
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.