SCT-230/STH-230 User's Manual Wireless Environment sensor Confidential
Contents 一、 二、 三、 四、 五、 六、 Product Overview ..........................................................................................1 Product Features.............................................................................................2 Installation operation .....................................................................................3 Precautions.....................................................................................................4 Troubleshooting ........................
一、Product Overview 1. Product Name:Wireless Contact Sensor 2. Model:SCT-230 3. Power Supply:CR123A Battery (3V) x 1 4. Dimensions (mm) and Accessories:Detect body, magnets, batteries, manual 82(L)mm x 25.5(W)mm x 17.5(H) mm 1. LED window 2. Reed switch position 3. Setting key (SET) 4. CR123A Battery 5.
二、Product Features 1. The wireless signal magnetic reed switch or the temperature and humidity of the transfer to the host、Panel Coordinator or Route, we can see that the doors and windows open and close or the temperature and humidity the current state, to prevent thieves invasive 2. 3.
三、Installation operation 1. Placed batteries in the battery holder, as shown below. (Note: In accordance with the polarity of the battery icon) SCT-230/STH-230 on both sides to suppress uprooted open into the battery is completed 2.
5. Lift connection: Press quickly the rear of the machine SET key twice (Double Key), this time flashing red light, inherent in 5 seconds behind the machine even by SET key twice, this opportunity about three seconds after the long flashed red, that means lifting connection successful. 6.
Please note that the machine being installed vertically, horizontally mounted upside down or avoid, avoid anti-removal operation does not function properly when installed, and cause excessive consumption phenomenon. 五、Troubleshooting 1. Abnormal conditions: SCT-230/STH-230 LED flashes the number of exceptions, do not recognize the connection status. Treatment: a. Ssure the battery is in good condition, the polarity is correct. b. Restore the factory default reset the connection. c.
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted.