Rugged Handheld Terminal - HT330 - User's Manual Version 1.
Revision History Date Change Description Version 20220523 First Published Version V1.
Preface About This Manual Thank you for purchasing the Unitech product. This manual explains how to install, operate and maintain our product. No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, such as photocopying, recording, or information storage and retrieval systems, without permission in writing from the manufacturer. The material in this manual is subject to change without notice.
1. 2. 3. which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure requirements, avoid direct contact to the transmitting antenna during transmitting.
CE RF Exposure Compliance For body-worn operation, this device has been tested and meets the ICNIRP guidelines and the European Standard EN 62209-2, for use with dedicated accessories, SAR is measured with this device at a separation of 0.5 cm to the body, while transmitting at the highest certified output power level in all frequency bands of this device. Use of other accessories which contain metals may not ensure compliance with ICNIRP exposure guidelines.
RoHS Statement This device conforms to RoHS (Restriction Of Hazardous Substances) European Union regulations that set maximum concentration limits on hazardous materials used in electrical and electronic equipment. Waste electrical and electronic equipment (WEEE) Unitech has set up a policy and process to meet the 2012/19/EU concerning electronic waste disposal.
Taiwan NCC Warning Statement NCC 警語 取得審驗證明之低功率射頻器材,非經核准,公司、商號或使用者均不得擅自變 更頻率、加大功率或變更原設計之特性及功能。 低功率射頻器材之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象 時,應立即停用,並改善至無干擾時方得繼續使用。 前述合法通信,指依電信管理法規定作業之無線電通信。低功率射頻器材須忍受 合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 SAR標準值 W/KG, 送測產品實測值為: (W/KG) 注意事項: 1. 使用過度恐傷害視力。 2. 使用30分鐘請休息10分鐘;2歲以下幼兒不看螢幕,2歲以上每天看螢幕不要超過 1小時。 3. 減少電磁波影響,請妥適使用。 Note: Within the 5.25-5.35 GHz band, U-NII devices will be restricted to indoor operations to reduce any potential for harmful interference to co-channel MSS operations.
Laser Information The Unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1. Class II and Class 2 products are not considered to be hazardous. The Unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
Battery Notice 1. To guarantee optimal performance, it is recommended that rechargeable batteries be replaced every year, or after 500 charging cycles are completed. It is normal for the battery to balloon or expand after one year or 500 cycles. Although it does not cause damage, it cannot be used again and must be disposed of according to the location's safe battery disposal procedures. 2. If a battery performance decreases more than 20%, the battery is at the end of its life cycle.
CAUTION! RISK OF EXPLOSION IF BATTERY IS REPLACED INCORRECTLY. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. 如果更換不正確之電池行事會有爆炸的風險 請依製造商說明書處理用過之電池 如果更换不正确之电池行事会有爆炸的风险 请依制造商说明书处理用过之电池 Battery charge notice It is important to consider temperature when the battery pack is charging. Charging is most efficient at normal room temperature or in a slightly cooler environment. It is essential that batteries are charged within the stated range of 0°C to 40°C.
Storage and safety notice Although charged batteries may be left unused for several months, their capacity may be depleted due to build up of internal resistance. If this happens, they will require recharging prior to use. Batteries may be stored at temperatures between -20°C to 60°C, however they may deplete more rapidly at higher temperatures. It is recommended to store batteries at room temperature. * The message above only applies to the usage of the removable batteries.
Hearing Damage Warning To prevent possible hearing damage, do not listen at high volume levels for long periods. xi © 2022 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Worldwide Support Unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest Unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan – Headquarters Europe Tel: +886-2-89121122 Tel: +31-13-4609292 E-mail: info@hq.ute.com E-mail: info@eu.ute.com Address: 5F, No.
Warranty Policy The following items covered under the Unitech Limited Warranty are free from defects during normal use: The warranty period is varied from each country. Please consult with your supplier or Unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user. xiii © 2022 Unitech Electronics Co., Ltd.
Table of Contents Preface........................................................................................................... i Regulatory Compliance Statements .............................................................. i Laser Information ........................................................................................ vi LED Information .......................................................................................... vi Battery Notice ............................................
HT330 User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the HT330 gift box. If something is missing or damaged, please contact your Unitech representative.
HT330 User’s Manual 1.2 Product Detail HT330 Product View Top View Rear View Front View Bottom View 10. 13MP Rear Camera 11. Mic 12. Battery Lock 13. Speaker 14. POGO Pin for Gun Grip 15. Holes for Hand Strap 16. Battery Cover 17. POGO Pin 18. USB Type-C Port 1. Scanner Window 2. LED Indicator 3. 5MP Front Camera 4. 4” LCD Display 5. Volume Key 6. Scanner Trigger Key 7. Power Key 8. Function Key 9. Mic 2 © 2022 Unitech Electronics Co., Ltd. All rights reserved.
HT330 User’s Manual 1.
HT330 User’s Manual Power Source Main Battery 3.85V 5200mAh Li-ION battery (removable), Operating time : over 20 hours (depending on the specific environment) Regulatory Approvals CE, FCC, NCC, CCC, SRRC, VCCI, TELEC, RoHS, BQB, N-Mark, BSMI Communication Bluetooth® Bluetooth® 5 supported WLAN 802.11 a/b/g/n/ac/d/e/h/i/j/k/r/v, 2.4G+5GHz, fast roaming, 2.4G+5GHz, hotspot GPS GPS/AGPS Sensors Gyroscope, G-sensor, E-Compass, Light & Proximity Sensor I/O Interfaces USB USB 2.
HT330 User’s Manual Software ․SOTI, Ivanti Wavelink, 42Gears, and MoboLink MDM Software Accessories ․3.85V 5200mAh battery ․USB Type C Cable ․Hand Strap ․Stylus with coil strap ․Glass Screen Protector ․Gun Grip ․Single Slot Charging Cradle ․Single Slot USB Cradle ․Boot Case Note: The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range.
HT330 User’s Manual 1.4 Getting Started 1.4.1 Inserting Micro SD Inserting the Micro SD Card Push the SD card holder to the right to unlock and flip the card holder to insert the SIM card. Close the card holder and push to the left to lock. Ensure that it is installed properly. 6 © 2022 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
HT330 User’s Manual 1.4.2 Remove Battery Cover to Install Battery 1. Push the battery lock to the right to unlock. 2. Grab the battery cover from the two recesses on the side, and lift to remove the battery cover. 3. Align the battery with the battery compartment, then push forward until you hear a click sound. 4. Press down the battery 4. to secure in place. 7 © 2022 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
HT330 User’s Manual 1.4.3 Install the Battery Cover Insert the battery cover in the direction as shown in the picture below: 1. There are three hooks on the bottom of battery cover, align the hooks with the recesses on the battery compartment. 2. Insert the battery cover up to 45 degrees (45°) angle, from bottom to top. 3. Press down the battery cover to secure in place. Make sure there is no gap between the device and the battery cover. 4. Push the battery lock to the left to lock.
HT330 User’s Manual 1.4.4 Remove the Battery Pick the battery from the bottom, and lift to remove. 1.4.5 Charging the Battery Charge the terminal for about 24 hours before using it for the first time. For regular use, charge the terminal for 4.5 hours to recharge the battery to full capacity. Please use the USB charging cable or the cradle to charge the terminal.
HT330 User’s Manual 1.4.6 Turning on the terminal for the first time It is recommended to fully charge HT330 before first use. You can now start up your device to set up the languages, WLAN setting, and date and time. Power Button Turn ON your device by pressing the power button on the terminal. 1.4.